Sony PMW-300, Руководство по обслуживанию

Страница: 69 / 134

2-12. Battery Case Assembly
Preparation
1. Remove the bottom panel assembly. (Refer to “2-5. Bottom Panel Assembly” )
2. Remove the inside panel assembly. (Refer to “2-6-1. Inside Panel Assembly” )
3. Remove the outside panel assembly. (Refer to “2-7-1. Outside Panel Assembly” )
4. Remove the rear panel assembly. (Refer to “2-8. Rear Panel Assembly” )
5. Remove the handle assembly. (Refer to “2-11-1. Handle Assembly” )
6. Remove the SxS slot assembly. (Refer to “2-9-1. SxS Slot Assembly” )
Procedure
1. Disconnect the harness from the connector on the RE-320 board.
2. Disconnect the harness from the connector on the RE-321 board.
3. Remove the four screws (P2 x 5) to detach the battery case assembly.
4. Remove the two screws (TP2 x 5) to detach the PSW board assembly.
Connector
(RE-321 board)
Battery case assembly
PSW board assembly
Connector
(RE-320 board)
Precision
screws
(P2 x 5)
Tapping screws
(TP2 x 5)
Harness
Harness
5. Install the removed parts by reversing the steps of removal.
PMW-300
2-41