Sony PDW-U4, Руководство по обслуживанию

Страница: 50 / 156

47
3-2-5. Error 6X
When an error is detected relating to a startup operation or relating to an adjustment before writing, one of the following error codes is displayed.
Continued
Main
Code
Sub
Code
ERROR/ALARM indicator Description Error remedy method Refer to section
Lighting
interval
Switching off
condition
60 E65 0.25 seconds Disc/Power An abnormal value was
detected in the
measurement of disc
eccentricity in the optical
block assembly 0Ach.
1. Eject the cartridge.
2. Insert again the ejected cartridge.
• In the case no error occurs:
The problem is fixed. Use the unit as it is.
• In the case the error occurs:
Go to step 3 in the error remedy method.
3. Insert another cartridge.
• In the case no error occurs:
The ejected cartridge is likely to be faulty.
Tip
For how to handle the defective cartridge, contact your local Sony Sales
Office/Service Center.
• In the case the error occurs:
A drive fault is likely.
4. Check that there is no dust or dirt on the turn table surface of the spindle
motor.
Note
If there is dust or dirt on the turn table surface of the spindle motor, the
disc chucking operation is not performed properly and the eccentricity
may increase.
－
EE5 0.25 seconds Disc/Power An abnormal value was
detected in the
measurement of disc
eccentricity in the optical
block assembly 0Bch.
F65 0.25 seconds Disc/Power An abnormal value was
detected in the
measurement of disc
eccentricity in the optical
block assembly 1Ach.
FE5 0.25 seconds Disc/Power An abnormal value was
detected in the
measurement of disc
eccentricity in the optical
block assembly 1Bch.
61 000 1 second Disc/Power Depletion of OPC area in
the recording disc was
detected.
1. Eject the cartridge.
Tip
The unit still can read data even though the unit cannot record data onto
the cartridge.
2. Insert another cartridge. Record data to the cartridge.
－