SONY NVD-U11E (
GB
,DE,FR,NL,IT,ES) 3-286-554-
11
(1)
8
9
SONY NVD-U11E (
GB
,DE,FR,NL,IT,ES) 3-286-554-
11
(1)
Completing the map addition/removal
The addition/removal of the map is completed when the above message is displayed.
1
Click “OK.”
2
Click “Exit” to quit the application.
For NV-U71T/U51 users:
Turn off the navigation unit by the POWER switch on its bottom, and disconnect the
cables. Turn on the navigation unit again.
For NV-U92T/U83/U82/U72T/U53/U52 users:
Disconnect the cables to use the navigation unit.
Important Q & A
1
Does your “Address Book” and “Home Address” data remain after the
update?
In many cases this data will remain, however, some data may generate an error
message as a result of the updated map data. In this case, you will need to delete
the particular “Address Book” and re-register it with the revised map data installed.
Prior to updating your navigation unit, please make a note of all “Address Book” for
safekeeping.
2
Is this disc compatible with Microsoft Windows
®
Vista
™
?
Yes. The “Windows Mobile Device Center 6.1” or later software is necessary to use
this disc (page 2).
3
Can previous map data be restored after updating the navigation unit?
No.
4
I cannot set the destination registered in “Address Book.” What should I
do?
You may have selected a destination out of the range of the selected map. Confirm
whether the selected destination is within the range of the selected map data.
The destination may not be set even within the range of the selected map, since the
map data was updated. If the selected destination is within the range of the selected
map, register the destination point again.
5
I cannot use a saved route. What should I do?
You may have selected a route out of the range of the selected map. Confirm whether
the selected route is within the range of the selected map data.
The route may no longer be set within the range of the selected map, since the
map data was updated. If the selected route is within the range of the selected map,
register the route again.
6
What should be done if a cable gets disconnected during the update
process?
Cancel the process, reconnect the cable and start over.
