Playing CDs and MDs
15
2
Do either
a)
or
b)
to create a program:
“Program In” appears in the display for a few
seconds at the beginning of either of the following
procedures.
a) When using the controls on the deck
Turn AMS until the track number you want
flashes in the display.
Until you press the AMS control to enter the
next track, you can continue turning the AMS to
change the track selection. Furthermore, until
you press
·
to start Program Play, you can
change any other track in the program (see
“Changing the track order” on this page).
If you enter the wrong track number
Press
0
or
)
until the wrong track number
flashes, then turn AMS to enter the correct track
number.
b) When using the remote
Press the number buttons to enter the tracks
you want to program in the order you want.
To program a track with a number over 10, use
the >10 button (see page 12).
If you enter the wrong track number
Press
0
or
)
until the wrong track number
flashes, then enter the correct track number
with the number buttons.
3
Press AMS, then repeat Step 2 to enter other
tracks.
Each time you enter a track, the total program time
is added up and appears in the display.
4
Press
·
to start Program Play.
To stop Program Play
Press
p
.
To cancel Program Play
While the deck is stopped, press PLAY MODE
repeatedly until “PROGRAM” disappears.
z
The program remains even after Program Play ends
When you press
·
, you can play the same program
again.
Notes
• The display shows “- -m - -s” instead of the total playing
time when the total playing time of the program exceeds
199 minutes.
• “ProgramFull” appears when you program over 25 tracks.
Erase the unnecessary tracks to enter other tracks.
• The program is erased when you turn off the deck or
disconnect the AC power cord.
Changing the track order
You can change the order of the tracks in your program
before you start playing.
To
Do the following:
Erase a track
Press
0/)
repeatedly until the
number of the unwanted track
flashes, then press CLEAR.
Erase all tracks
Press CLEAR repeatedly until all the
track numbers disappear.
Add a track at the
beginning of the
program
Press
0
repeatedly until the cursor
flashes before the first track number,
then do Step 2 above.
Add a track in the
middle of the program
Press
0/)
repeatedly until the
track number which will precede the
new track flashes. Press AMS to
display flashing cursor, then do Step 2
above.
Add a track to the end
of the program
Press
)
repeatedly until the cursor
flashes after the last track number,
then do Step 2 above.
Replace a track
Press
0/)
repeatedly until the
number of the track to be changed
flashes, then do Step 2 above.
z
You can check the playing time and title of a track
before you add or erase it
Press TIME or TIME/CHAR while the number of the
track is flashing in the display. The playing time and
the title of the track (if the track is labeled) will appear.
