Sony MVS-8000X System, Руководство пользователя

Страница: 56 / 1310

Ch
apt
er 2
Me
nu
s
an
d Cont
rol P
ane
l
56
Names and Functions of Parts of the Control Panel
For details of assignment and selection of
keys 5 to 8, see the following sections in
Appendix (Volume 1): “Assigning Buttons
for Selection of Keys 5 to 8 in the Setup
Menu” (page 544) and “Selecting Input
Signals for Keys 5 to 8 in the Cross-Point
Control Block” (page 546).
Key 1 row: The buttons in this row select
the key 1 or key 3 signals to be inserted
into the video on this M/E bank or
PGM/PST bank.
To select the key 1 fill signal, check
that the right-hand [KEY3] button in
the M/E bank (or the [DSK3] button in
the PGM/PST bank) is off, then press
the button assigned to the desired
signal. To select the key 3 fill signal,
press the [KEY3] button, turning it on.
While the [UTIL] button on the right
hand side is held down, these buttons
are assigned to the DME external video
bus allowing you to select the signal on
that bus.
Key 2 row: The buttons in this row select
the key 2 or key 4 signals to be inserted
into the video on this M/E bank or
PGM/PST bank.
To select the key 2 fill signal, check
that the right-hand [KEY4] button in
the M/E bank (or the [DSK4] button in
the PGM/PST bank) is off, then press
the button assigned to the desired
signal. To select the key 4 fill signal,
press the [KEY4] button, turning it on.
While the [UTIL] button on the right
hand side is held down, these buttons
are assigned to the DME utility 1 or 2
bus as follows.
•
When the [KEY 4] button is off:
DME utility 1 bus
• When the [KEY 4] button is on:
DME utility 2 bus
Background A row: Press the desired
button to select the signal as the current
background video on this M/E bank or
PGM/PST bank.
While the [UTIL] button on the right
hand side is held down in Hold mode,
these buttons are assigned to the utility
1 bus, and can be used to select the
signal on that bus.
Background B row: Press the desired
button to select the signal as the
background video after the transition
on this M/E bank or PGM/PST bank.
While the [UTIL] button on the right
hand side is held down in Hold mode,
these buttons are assigned to the utility
2 bus, and can be used to select the
signal on that bus.
Reentry buttons: These allow you to select
the video created on another bank as
background A or B or one of the keys 1
to 8. For example, to use the video
created on the M/E-1 bank as
background B on the M/E-2 bank, press
the reentry button [M/E 1] in the
background B row of buttons on the M/
E-2 bank.
Cross-point button numbers
Cross-point button and reentry buttons are
respectively numbered.
For details, see “Cross-point button
control block button numbers” (page 152).
Assigning signals to button
You can assign a signal to each button using
the Setup menu.
For details on the operation, see “Cross-
Point Settings (Xpt Assign Menu)” in
Chapter 19 (Volume 3).
Visual indications on cross-point buttons
For details on the operation, see “Colors of
lit cross-point buttons” (page 156).