Sony MG40 Series, Справочник по командам

Страница: 83 / 140

(E)
2-7
MG40 Series
2-5. When Both the Command Interface and Data Interface Are Used
While referring to “2-4. Setting Examples,” make the connection to the command interface, and establish
the necessary settings.
2-5-1. Setting the Measurement Conditions
For details on “Switching over to the setup mode,” “Acquiring the confi guration information” and
“Comparator settings,” refer to
“2-4-2. Setting the Measurement Conditions” .
Setting the gateway address
Set the gateway address if the network requires that it be set. For details on whether it is needed and its
setting, consult the network administrator.
<Example> Setting 192.168.1.254
1
Use the NGW command to set the gateway address.

NGW command
NGW=192.168.1.254 CR LF
OK000 CR LF
Setting the data transmission protocol
Set the protocol which is to be used by the data interface.
<Example> Setting TCP
1
Use the NPC command to set “0” which signifi es TCP.

NPC command
NPC=0 CR LF
OK000 CR LF
Setting the data transmission port number
Set the port number which is to be used by the data interface.
First consult with the network administrator, and use a port number whose use is permitted.
Note
Bear in mind that if a port number already being used by the existing network is set by mistake, not only
will it be impossible to receive data but the operations of the other network devices may be impeded as
well.
Reference
Usually, 49152 or a higher number is used as the port number.
Port numbers 1 to 1023
: Th ese may have already been reserved by regular internet services.
Port numbers 1024 to 49151 : Th ese may already be used by other systems.
<Example> Setting 49154 as the port number
1
Use the NPN command to set 49154 as the port number.

NPN command
NPN=49154 CR LF
OK000 CR LF