MDR-XB950B1
6
2-5. HOUSING (L) ASSY (L-ch)
2-6. FRONT PLATE (R) ASSY (DR2) (R-ch)
4
housing (L) assy
1
Remove the shaft of hanger block
from the housing (L) assy.
2
Remove the shaft of hanger block
from the housing (L) assy.
–
L-ch
–
Note:
When attaching the housing (L) assy to
the hanger block, be sure to attach from
the side with the relay cable first.
3
Draw the relay cable out of
the hole in housing (L) assy.
hanger block
hole
4
front plate (R) assy
(DR2)
2
Remove the front plate (R) assy
in the direction of the arrow.
[red]
[natural]
:LUHVHWWLQJ
–
5FK
–
BATT board
3
Remove the solder.
[red]
3
Remove the solder.
[natural]
to front plate (R) assy (DR2)
Note 1:
When installing the front plate (R) assy (DR2),
arrange the driver wire into this portion.
1
two tapping screws (B2)
Note
2:
Be careful not to let the
removed screws stick to
the magnet of the driver.
1
two tapping screws (B2)
Note
2:
Be careful not to let the
removed screws stick to
the magnet of the driver.
driver
filament tape
(sub material)
