Precautions
15
GB
Precautions
On safety
• Operate the unit on 100 – 240 V AC, 50/60 Hz.
• Should any liquid or solid object fall into the cabinet,
unplug the unit and have it checked by qualified Sony
personnel before operating it further.
• Unplug the unit from the wall outlet or turn off the power
switches on the front and rear of the unit if it is not to be
used for several days.
• To disconnect the cord, pull it out by the plug. Never pull
the cord itself.
• The wall outlet should be near the unit and easily
accessible.
• The unit is not disconnected from the AC power source
(mains) as long as it is connected to the wall outlet and
the main power switch is turned on.
• Do not place your hand or objects near the ventilation
holes. The air coming out is hot.
• Have at least two people carry and handle the unit, to
avoid accidents or injury.
• Avoid using an extension cord with a low voltage limit,
as it may cause short-circuiting and physical injury.
• To carry the unit, be sure to hold the bottom of the unit.
• Do not catch your finger between the unit and surface of
the floor when moving the unit installed on the floor.
• Be careful not to catch your finger in the cooling fan.
On installation
• Allow adequate air circulation to prevent internal heat
build-up. Do not place the unit on surfaces (rugs,
blankets, etc.) or near materials (curtains, draperies) that
may block the ventilation holes. Leave space of more
than 10 cm (4 inches) between the wall and the unit. Be
aware that room heat rises to the ceiling; check that the
temperature near the installation location is not
excessive.
• Do not install the unit in a location near heat sources
such as radiators or air ducts, or in a place subject to
direct sunlight, excessive dust or humidity, mechanical
vibration or shock.
• To avoid moisture condensation, do not install the unit in
a location where the temperature may rise rapidly.
Caution
The projector is equipped with ventilation holes (intake) at
the upper, left and right sides, and ventilation holes
(exhaust) at the rear side.
Do not block or place anything near these holes, or internal
heat build-up may occur, causing damage to the unit.
On cleaning
To keep the cabinet looking new, periodically clean it with
a soft cloth. Stubborn stains may be removed with a cloth
lightly dampened with a mild detergent solution. Never
use strong solvents, such as thinner, benzene, or abrasive
cleansers, since these will damage the cabinet.
On repacking
Save the original shipping carton and packing material;
they will come in handy if you ever have to ship your unit.
For maximum protection, repack your unit as it was
originally packed at the factory.
