Sony LMD-940W, Руководство по эксплуатации

Страница: 9 / 31

Location and Function of Parts and Controls
9
Location and Function of Parts and Controls
Front Panel
a
Tally lamp
You can check the status of the monitor by the color of
the tally lamp.
The tally lamp lights in red, green or amber according to
the setting of PARALLEL REMOTE in the REMOTE
menu.
b
Protection plate
You can detach the protection plate by removing the
four screws.
c
i (headphones) jack
The audio signal which is selected by the input select
button is output in stereo sound.
d
Speaker
The audio signal which is selected by the input select
button is output in monaural sound (L + R).
When SDI signals are input, the audio signal of the
channel which is selected in AUDIO SETTING of the
USER CONFIG menu is output (see page 21).
The audio signals from the speaker are output from the
AUDIO OUT connector on the rear (see page 12).
Audio signals will not be output when headphones are
connected to the
i jack.
e
Stand
Pull the stand toward you to tilt the monitor screen by
15°. When using the optional VF-510 Monitor ENG Kit,
set the stand at positions B and C. (see “Using the stand”
on page 10).
f
Input select buttons
Press to monitor the signal input to each connector.
SDI button : to monitor the signal through the SDI IN
connector
HDMI button : to monitor the signal through the
HDMI connector
COMPOSITE button : to monitor the signal through
the COMPOSITE IN connector
g
Function buttons
You can turn the assigned function on or off.
The factory setting is as follows;
F1 button : BRIGHTNESS
F2 button : CONTRAST
F3 button : CHROMA
F4 button : SCAN
F5 button : H/V DELAY
F6 button : VOLUME
F7 button : I/P MODE
You can assign various functions in FUNCTION
BUTTON SETTING of the USER CONFIG menu.
i
1
1 2
4 9 6 7 8 5 3