Tuner
19
GB
Other Operations
To
Tune in a station with a
weak signal
Stop scanning
Change the preset
number
Change the preset station
Cancel presetting
To change the AM tuning interval
(Except for the Middle Eastern
model)
The AM tuning interval is factory-set to 9 kHz
(10 kHz in some areas). To change the AM
tuning interval, tune in any AM station first,
then turn off the system. While holding down
TUNER ENTER, press
?/1
to turn the system
back on. When you change the interval, all the
AM preset stations will be erased. To reset the
interval, repeat the same procedure.
Note
You cannot change the AM tuning interval in the
Power Saving Mode.
Tips
• The preset stations are retained for half a day even
if you unplug the power cord or if a power failure
occurs.
• To improve broadcast reception, reorient or move
the supplied antennas near a window or outdoors.
5
Press TUNING –/+ repeatedly to select
the desired preset number.
6
Press TUNER ENTER.
“COMPLETE” appears.
7
Repeat steps 1 to 6 to store other
stations.
Setting presets through
manual tuning
1
Press TUNER/BAND repeatedly to
select “FM” or “AM.”
2
Press TUNING MODE repeatedly until
“MANUAL” appears.
3
Press TUNING –/+ repeatedly to tune in
the desired station.
4
Press TUNER MEMORY.
5
Press TUNING –/+ repeatedly to select
the desired preset number.
6
Press TUNER ENTER.
“COMPLETE” appears.
7
Repeat steps 1 to 6 to store other
stations.
Preset number
Do this
Follow the procedure
described in “Setting
presets through manual
tuning.”
Press TUNING MODE.
Start over from step 1.
Start over from step 1.
Press TUNER MEMORY.
Preset number
