19
REMOV
AL
AND REPLACEMENT OF THE MAIN
-
BRACKET
BOTT
OM PLA
TES.
(1) REMOVING THE PLA
TES
In the event of servicing being required to the solder side of the D Board printed wiring board,
the bottom plates fitted to the main chassis bracket require to be removed.
This is performed by cutting the gates with a sharp wire cutter at the locations indicated by the
arrows.
Note :
There are 3 plates fitted to the main bracket and secured by3 gates.
Only remove the necessary plate to gain access to the printed wiring board.
(2) REFITTING THE PLA
TES
Because the plates differ in size it is important that the correct plates are refitted in their original
location.
Please note that the plates need to be rotated 180 degrees from their cut position to allow the
tabs to be fitted into their catch positions.
For safety reasons, on no account should the plates be
removed and not refitted after servicing.
£
Ta
b
Catch
Содержание KV-34FQ75A
Страница 30: ...30 Memo ...
Страница 36: ...E R G B OUT CHROMA 50 49 ...
Страница 37: ...51 E PRINTEDWIRING BOARD A side E PRINTEDWIRING BOARD B side ...
Страница 38: ...52 M1 PRINTEDWIRING BOARD B side M1 PRINTEDWIRING BOARD A side ...