Sony KP-65XBR10W - 65" Projection Tv, Руководство по обслуживанию

Страница: 52 / 150

– 52 –
KP-57XBR10W/65XBR10W
RM-Y907 RM-Y907
MUTING
OFF
AUDIO
TV/SAT
PICTURE
MODE
FREEZE
SWAP
LEFT RIGHT
ACTIVE
GUIDE
WIDE MODE
JUMP
1
4
7
2
5
8
0
3
6
9
TV/VIDEO ANT
ENTER
MENU
RESET
CH VOL
POSITION ZOOM IN
FUNCTION DVD/VCR SATCABLE
TV
TV
TV
DISPLAY
DVD/
VCR
SAT/
CABLE
PAWER
3-10. REGISTRATION ADJUSTMENT (PJE)
• FUNCTION OF BUTTONS OF REMOTE
COMMANDER FOR PJE MODE.
[SETUP FOR ADJUSTMENT]
• Current flow in circuit should be stable before attempting
adjustment. So wait 5 minutes after turning on the TV power.
• At the 4 insides of the screen, locate the middle. Use a tape
measure to identify the middle.
• Connect the pattern generator amd feed the signal easy to
judge the center of picture. Make the ceuter of picture to the
mechanical center
: middle
• Separate adjustments are required for multiple modes and
should be done in the following order (as each mode requires a
separate adjustment):
• FULL (NORMAL) mode
• WIDE ZOOM mode
• ZOOM mode
• 1080i (Video 5 input mode)
In all these modes, both color convergence and geometry
adjustments are required.
• In order to do the 1080i (Video 5) mode adjustment, you must
follow this procedure:
VIDEO 5 forced 1080i mode setting:
Set OP 03 1080 to 001 in the service mode.
1. Set to the service mode by pressing quickly keys on the remote
commander in the standby mode in the following order:
[DISPLAY]
n
5
n
[VOL+]
n
[TV POWER]
2. Change TV mode to the video input mode.
3. Change the VDSP mode to the PJE 00 FDIS.
PJE 00 00
FDIS
4. Set FDIS data to “01” to display the registration data of each
spot in the fine adjustment.
PJE 00 01
FDIS
5. Press
6
to display the test signal (crosshatch) on the screen.
6. Select GRN CENT(*) with the
1
and
4
keys on the remote
commander and check that the adjustment data is now “000”
both vertically and horizontally.
GRN 000 000
CENT
(H) (V)
*: In the factory preset, “GRN CENT” appears on the screen first.
In case of other colors “RED” or “BLU”, change color by
every pressing
3
key.
7. Cover the both red and blue picture lenses with the lens caps to
INIT*: Press 7, "INIT" green letters appear on the screen.
Then press ENTER, all the PJE data are reset.
READ*: Press 0, "READ" green letters appear on the screen.
Then press ENTER, all the PJE default data are
restored.
Note : Internal patterns are used for geometry and convergence
adjustments. However, sizing and centering must be done with
the use of an external generator. The recommended pattern
would be a monoscope, or equivalent pattern, which would
provide the means to adjust both the linearity and sizing of the
picture.
Color select
GRN
n BLU n RED
Test signal select
crvideo signal
dots+video signal
crblack
dots+black
off
Mode select
Coarse adjustment
Fine adjustment
ENTER
READ*
Adjustment item
up
Adjustment item
down
INIT*
data up/down