14
C:\Shere\FM\38676511KP53XBRAE\01GB06INTAE.fm
masterpage:Left
Model name1[KP-53XBR300] Model name2[KP-61XBR300]
[3-867-65111 (1)]
Disconnect all power sources before making any connections.
SELECT OUT gives you the ability to use a
second VCR to record a program being played by
the primary VCR or to perform tape editing and
dubbing.
1
Connect the VCR intended for playback using
the connection instructions on page 7 of this
manual.
2
Using an AUDIO/VIDEO cable, connect
AUDIO and VIDEO IN on the VCR intended
for recording to AUDIO and VIDEO OUT of
SELECT OUT on the projection TV.
Notes:
• Do not change the input signal while editing
through SELECT OUT.
• When connecting a single VCR to the projection
TV: if VCR LINE OUT is connected to VIDEO IN
on the projection TV, do not connect the SELECT
OUT on the projection TV to the VCR LINE
INPUT (see right). Doing so will cause program
interference and other viewing problems.
• You can select the output signal from SELECT
OUT from the SET UP menu. (see “SELECT
OUT” on page 40)
Connecting Two VCRs for
Tape Editing
S VIDEO
VIDEO
AUDIO
L
R
R
VIDEO
(MONO)
IN
IN
CONTROL S
IN OUT
OUT
VIDEO 4
VIDEO 1
VIDEO 3
VIDEO 5 (DTV)
SELECT
Y
P
B
P
R
Y/G
HD
VD
P
B
/B
P
R
/R
L
(MONO)
R
L
AUDIO
AUDIO
COMPONENT
VHF/UHF
AUX
AUDIO R AUDIO L VIDEO
LINE
OUT
OUT
IN
AUDIO R AUDIO L VIDEO
LINE
IN
OUT
IN
(Rear of projection TV)
AUDIO-R
VCR (for playback)
AUDIO-L
2
VIDEO
VMC-810S/820S
(not supplied)
VIDEO
AUDIO-L
AUDIO-R
VCR (for recording)
VMC-810S/820S
(not supplied)
1
LINE
OUT
IN
SELECT
OUT
VIDEO IN
Indicates direction
of signal
(Rear of projection TV)
KP-53XBR300.book Page 14 Wednesday, June 30, 1999 2:22 PM
