− −
Additional Information for Using Sony Wall-Mount Bracket (SU-WL500)
3
Adjust the angle of the Mounting Hook using the hexagon wrench supplied
with the Wall-Mount Bracket.
When installing the TV parallel to the wall (0 degrees), adjustment of the Mounting Hook angle
(procedures
and
below) is not necessary. Make sure that each arm base
X
is screwed in securely.
Remove the two screws from the arm base
X
of the Mounting Hook. Choose the holes
corresponding to the desired angle (5, 0, 5 or 0 degrees).
Adjust the angles of the top
Y
and bottom
Z
arm to fit the corresponding hole, and firmly
secure each arm using the two screws removed in the previous procedure
.
Hexagon
wrench
✍
• Be sure to adjust the right and left arms to the same angle.
• Make sure that the two arm bases are screwed in securely.
CAUTION
Be careful not to pinch your fingers when adjusting the angle of the Mounting Hook.
4
Remove the screws from the back of the TV.
Do not remove any other screws from the TV.
5
Lift the TV off the stand. Make sure that you carry out this task with at least two
or three people.
Do not attempt to lift the TV by yourself.
Step 5: Installing the TV on the wall
Refer to the Instructions for SU-WL500.
✍
• When you put the TV back on the stand, reverse the above steps.
• When moving the TV, do not squeeze the bottom of the front panel too strongly.
• Remove the screws or install the Mounting Hook on a stable and level surface.
