KDL-32BX355/40BX455/46BX455
16
Components not identified by a part number or
description are not stocked because they are seldom
required for routine service.
The component parts of an assembly are indicated by the
reference numbers in the far right column of the parts list
and within the dotted lines of the diagram.
*
Items marked with an asterisk are not stocked since
they are seldom required for routine service. Expect
some delay when ordering these components.
NOTE: The components identified by shading
and
!
mark are critical for safety. Replace only
with part number specified.
NOTE: The components identified by a red outline and a
mark contain
confidential information. Specific instructions must be adhered to whenever
these components are repaired and/or replaced.
See Appendix A: Encryption Key Components in the back of this manual.
SECTION 4 - DISASSEMBLY/PART NUMBER INFORMATION
TABLE-TOP STAND AND REAR COVER REMOVAL
A
Gently place LCD TV face down onto a soft cloth and remove 3 screws from Table-Top Stand.
B
Remove screws from Rear Cover.
15 from KDL-32BX355 Only
17 from KDL-40BX455 Only
19 from KDL-46BX455 Only
CAUTION: Do not damage the Power Board Connector and AC Power Cord when removing the Rear Cover.
REF. NO.
PART NO.
DESCRIPTION
[ASSEMBLY INCLUDES]
REF. NO.
PART NO.
DESCRIPTION
[ASSEMBLY INCLUDES]
1
4-423-357-01
REAR COVER (32APOT) [2]
(KDL-32BX355 ONLY)
1
4-423-358-01
REAR COVER (40APOT) [2]
(KDL-40BX455 ONLY)
1
4-423-359-01
REAR COVER (46APOT) [2]
(KDL-46BX455 ONLY)
2
4-410-252-01
BRACKET, VESA (APOT)
3
X-2584-208-1
STAND ASSEMBLY (32APOT)
(KDL-32BX355 ONLY)
3
X-2584-209-1
STAND ASSEMBLY (40APOT)
(KDL-40BX455 ONLY)
3
X-2584-210-1
STAND ASSEMBLY (46APOT)
(KDL-46BX455 ONLY)
▲
2-580-608-01
SCREW, +PSW M5X16
(SCREWS TO ATTACH TABLE-TOP STAND TO LCD TV)
For product protection and safety reasons, Sony strongly recommends
that you use the screws provided with the TV.
CAUTION: These screws cannot be used to secure the TV to the Wall
Mount Brackets
△
2-580-640-01
SCREW, +BVTP2 4X16
●
2-580-592-01
SCREW, +PSW M3X8
○
4-159-298-01
SCREW, +PSW M4X10
3
2
1
C
Carefully lift Rear Cover from bottom side and push
forward to release top hooks.
D
Hold Power Supply Cord while lifting up Rear
Cover, then pass Power Supply Cord through Rear
Cover opening.
Do not pull the AC Power Cord or damage
the connector on the Power Board.
