- 13 -
The TT modes described below are available by selecting the two
relevant digits. You can exit the ‘TT Mode’ by entering 00, by
pressing the ‘Analog’ or the ‘Digital’ button, by switching the TV
set into stand-by mode, or by powering the TV set off.
3-3. TT MODE
Note :
To place the Remote Commander in ‘TT Mode’ press the
following buttons together for approximately five seconds.
To use the Remote Commander in ‘TT Mode’ press the
‘Rewind’ button on the Remote Commander twice.
TT will then appear in the bottom right hand corner of the TV.
i+
5
+
(ON SCREEN (DIGIT 5) () (TV)
DISPLAY)
(ON SCREEN
DISPLAY)
(DIGIT 5)
()
(EXTERNAL INPUT)
(DIGIT 5)
()
To take the Remote Commander out of ‘TT Mode’ press the
same buttons together for approximately five seconds.
Rewind Button
00
'TT' mode off
03
Set volume to 35%
04
Set volume to 50%
05
Set volume to 65%
06
Set volume to 80%
07
Ageing mode on
08
Shipping Condition
09
WB Levels Check
11
Panel_id A
12
Panel_id B
15
Speaker_id A
16
Speaker_id B
19
Factory toggle mode (ON/OFF)
27
CBA mode toggle (ON/OFF)
31
ECS mode toggle (ON/OFF)
32
Set DVB-T channel table
33
Set DVB-C channel table
36
Full HD HDMI EDID Write
37
WXGA HDMI EDID Write
41
Re-initialise NVM
43
Select Dual Sound "A"
44
Select Dual Sound "B"
45
Select Dual Sound "Mono"
46
Select Dual Sound "Stereo"
48
Set NVM as non-virgin
49
Set NVM as virgin
51
Clear authenticated CAM History
52
Clear service shunning cache
53
Enable/Disable DVB-C manual tuning
75
Set Centred Balance
76
Set Volume to Max
77
Set Volume to Min
78
Set Balance Full Left
79
Set Balance Full Right
81
Digital BER Display
84
TS CI Path Through
87
Front Panel Button Test
89
LED Test
92
TS CI Path Through With Reed Solomon Off
