7
Preparations
Change connections and cable
wiring
The supplied LAN cable is connected to the camera at the
factory.
To change connections and cable wiring to suit your
requirements, perform the following steps.
◆
When you route the cables from the side of the camera
unit, see “c) If you use the side conduit hole”.
a) If you use the camera with its factory setting
The preparation is completed.
b) If you use a commercially available LAN cable
Use a LAN cable with a cable diameter between ø5.5 mm
(
7
/
32
inches) to ø6.5 mm (
9
/
32
inches).
1
Remove the dome casing. (See “Installing the Camera
- Step 1” on page 9.)
2
Remove the supplied LAN cable. (b-1)
3
Attach the sealing rubber to the LAN cable. (b-2)
Cut-off the supplied sealing rubber at the proper position,
and insert the cable into the rubber. (b-3)
Notes
• Do not pull the cable strongly. The cable may disconnect
from the connector.
• Waterproof the connection part between the cable and
the sealing rubber.
c) If you use the side conduit hole
1
Remove the side conduit hole cover.
Note
When using a flanged pipe or cable gland, refer to
“Important precautions” (page 12).
d) If you use a multi connector cable (supplied)
When you use a cable other than the network cables, use
the multi connector cable (supplied).
1
Remove the dome casing. (See “Installing the Camera
- Step 1” on page 9.)
2
Remove the sealing rubber of the camera.
3
Attach the multi connector cable (supplied) properly
to the hole which has been covered with the sealing
rubber.
Note
Water may enter if not attached properly.
4
Connect the AC/DC and 10Pin (Audio, EXT CTRL)
cables to the connectors, and store cables in the hooks.
b-1
Press the rubber.
b-2
b-3
x
y
z
Reference position
x: cable diameter ø5.5 mm
(
7
/
32
inches)
y: cable diameter ø6 mm
(
1
/
4
inches)
z: cable diameter ø6.5 mm
(
9
/
32
inches)
Hook
Audio,
EXT
CTRL
24 V
/
12 V
