Sony hmd-m11, Руководство по обслуживанию

Страница: 31 / 105

– 31 –
4-6. OPERATING THE CONTINUOUS PLAYBACK
MODE
4-6-1. Entering the Continuous Playback Mode
1. Set the disc in the unit. (Whichever recordable discs or discs
for playback only are available.)
2. Press the = 0 button or ) + button and display
“CPLAY MODE”.
3. Press the YES button to change the display to “CPLAY MID”.
4. When access completes, the display changes to
“C1=
AD=
”.
Note: The numbers “ ” displayed show you error rates and ADER.
4-6-2. Changing the Parts to be Played-back
1. Press the YES button during continuous playback to change
the display as below.
2. When access completes, the display changes to
“C1= AD= ”.
Note: The numbers “ ” displayed show you error rates and ADER.
4-6-3. Ending the Continuous Playback Mode
1. Press the NO button. The display will change to “CPLAY
MODE”.
2. Press the
6
button and remove the disc.
Notes:
1. The playback start address for IN, MID, and OUT are as fol-
lows.
IN
: 40h cluster
MID : 300h cluster
OUT : 700h cluster
In case you want to display the address of the playback posi-
tion on the display, press the DISPLAY button and display
“CPLAY (
)”.
2. The NO button can be used to stop playing anytime.
4-7. OPERATING THE CONTINUOUS RECORDING
MODE
4-7-1. Entering the Continuous Recording Mode
1. Set the MO disc in the unit. (Refer to note 3.)
2. Press the
= 0
button or
) +
button and display
“CREC MODE”.
3. Press the YES button to change the display to “CREC MID”.
4. When access completes, the display changes to “CREC (
)”
and PRESET lights up.
Note: The numbers “ ” displayed shows you the recording posi-
tion address.
4-7-2. Changing the Parts to be Recorded
1. When the YES button is pressed during continuous record-
ing, the display changes as below. ( PRESET indication turns
off during change-over of display.)
2. When access completes, the display changes to “CREC ( )”
and PRESET lights up.
Note: The numbers “ ” displayed shows you the recording posi-
tion address.
4-7-3. Ending the Continuous Recording Mode
1. Press the NO button. The display will change to “CREC
MODE” and PRESET goes off.
2. Press the
6
button and remove the disc.
Notes:
1. The recording start address for IN, MID, and OUT are as fol-
lows.
IN
: 40h cluster
MID : 300h cluster
OUT : 700h cluster
2. The NO button can be used to stop recording anytime.
3. During the test mode, the erasing-protection tab will not be
detected. Therefore be careful not to set the continuous re-
cording mode when a disc not to be erased is set in the unit.
4. Do not perform continuous recording for long periods of time
above 5 minutes.
5. During continuous recording, be careful not to apply vibra-
tion.
CPLAY MID CPLAY OUT CPLAY IN
CREC MID CREC OUT CREC IN