Sony HKSR-5803HQ, Руководство по эксплуатации

Страница: 141 / 211

141
6-1 Basic Automatic Editing
Cha
p
te
r 6
E
d
it
ing
Monitoring signals during editing
During editing, you can monitor signals between preroll
and postroll points, including portions between IN and
OUT points, through the simultaneous playback. This
allows you to monitor the video and audio signals that are
just being edited.
The video and audio signals that can be monitored are
shown in the diagram below.
To perform automatic editing
To carry out automatic editing, press the AUTO button,
turning it on, then press the REC/EDIT button.
During editing the REC/EDIT button lights up, and goes
off at the end.
To stop automatic editing
Press the OUT button while holding down the ENTRY
button.
The point where the OUT button is pressed is treated as an
OUT point and editing stops.
To confirm the results of the editing
Press the PREVIEW/REVIEW button to confirm the edit
results. When the view ends, the tape rewinds to the OUT
point, then stops.
Modifying edit points for automatic editing
later
After you perform automatic editing, the time data of IN,
OUT, AUDIO IN or AUDIO OUT points remain stored in
memory. The stored data can be used later to modify edit
points or to execute automatic editing again.
Follow the procedure below to modify edit points after
executing automatic editing.
1
In the HOME menu, press the ALT/
[F10]
(LAST
EDIT) buttons.
The edit points used in the last automatic edit are
restored.
2
Modify the edit points.
For details on modifying edit points, see “6-1-10
Modifying Edit Points” on page 137.
3
Press the REC/EDIT button.
The VTR performs automatic editing.
IN point
(recorder VTR)
OUT point
(recorder VTR) (recorder VTR)
AUTO button
PREVIEW/REVIEW button
REC/EDIT button
OUT button
ENTRY button