Sony HKSR-5803HQ, Руководство по эксплуатации

Страница: 137 / 211

137
6-1 Basic Automatic Editing
Cha
p
te
r 6
E
d
it
ing
The tape is rewound to a point before the edit start
point by the amount determined by the preroll time
setting.
When the
[F1]
(TIMER SEL) button in the TC menu is set
to CTL mode, cuing up is slightly slower than in TC mode.
This is to maintain the accuracy of the CTL signals.
You can set up the VTR so that priority is placed on cuing
accuracy or speed. Change the setting of the VTR SETUP
menu item 403 “CUEUP BY TC” and menu item 404
“CUEUP BY CTL”.
Changing the preroll time
The preroll time is factory set to 5 seconds, but can be set
to any time between 0 and 30 seconds, in 1-second steps.
For details, see “4-2-5 Setting the Preroll Time
(PREROLL TIME)” on page 63.
When changing the preroll time, set it so that the recorded
section prior to the edit start point is longer than the preroll
time.
The preroll time used in automatic editing is the preroll
time set for the recorder.
6-1-9 Previewing
Follow the procedure below to preview the edit.
To preview the edit, press the AUTO button to switch to
AUTO mode, then press the PREVIEW/REVIEW button.
During previewing, the PREVIEW/REVIEW button lights
up.
After previewing, correct the edit points as required, then
do the preview again.
For details on modifying edit points, see “6-1-10
Modifying Edit Points” on page 137.
To stop previewing
Press the STOP button.
The tape stops immediately.
To rewind the tape to the preroll point
Press the PREROLL button.
To rewind the tape to the edit point
Press the PREROLL button together with the button
corresponding to the edit point.
Monitoring signals during previewing
During previewing, you can monitor the following video
and audio signals on a monitor connected to the recorder
VTR:
• Between preroll and IN points: Playback signal of the
recorder VTR can be monitored.
• Between IN and OUT points: Playback signal of the
player VTR can be monitored in E-E mode.
• Between OUT and post-roll points: Playback signal of
the recorder VTR can be monitored.
This may be illustrated as shown below:
6-1-10 Modifying Edit Points
If an edit point is incorrectly set, for example, if an OUT
point is located before an IN point, or the length of an edit
section is different for the recorder and player VTRs, the
time data for the incorrectly set edit point flash indicating
that the VTR cannot perform editing or previewing. In this
case, delete the edit point, then set a new one correctly.
You can also move an edit point position in one-frame
units.
Note
AUTO button
PREVIEW/REVIEW
button
STOP button
PREROLL button
IN point
(recorder VTR)
OUT point
(player VTR) (recorder VTR)