Sony HKSR-101, Руководство по эксплуатации

Страница: 23 / 128

Chapt
er
3
P
rep
ar
at
ions
23
3-1 Assembly
5
Rotate the assist lever back to its original (lock)
position to align the LOCK
V
mark on the SRW-1
with the
v
mark on the SRPC-1. (See “To lock” in the
previous figure.)
When you do this, check to be sure that the release
knob
(see the following figure) is all the way in.
Next, by attempting to rotate the assist lever again to
the lock position, check to be sure that now the assist
lever will not go beyond half the way and that the
SRW-1 keeps joined to the SRPC-1.
Caution
The SRW-1 and SRPC-1 are not properly joined
unless the release knob is all the way in. They may
come apart, or the SRW-1 may fall off.
6
Rotate the lock lever on the side panel of the SRPC-1
in the direction of the arrow to lock the joint between
the SRPC-1 and SRW-1.
7
Remove the two screws from the holes on the SRW-1,
and use these two screws to mount the supplied assist
lever holding bracket on the SRW-1.
To detach the SRW-1 from the SRPC-1
1
Place the joined SRPC-1 and SRW-1 on a flat, stable
surface of a bench, table or the like.
2
Unscrew the assist lever holding bracket from the
body of the SRW-1.
3
Rotate the lock lever on the side panel of the SRPC-1
in the direction of the arrow to unlock the joint
between the SRPC-1 and SRW-1.
4
While pulling out the release knob on the side panel of
the SRPC-1, rotate the assist lever in the direction of
arrow and then slide the SRW-1.
The mark on the SRW-1 is aligned with the v mark
on the SRPC-1. (See “To release” in the figure on
page 22.)
This part is visible.
Release knob is
not all the way in. Release knob is
all the way in.
Lock lever
Assist lever
holding bracket
Screws (
×
2)
Lock lever