Sony HKSR-101, Руководство по эксплуатации

Страница: 22 / 128

Chapter
22
3-1 Assembly
3
Preparations
3-1 Assembly
3-1-1 Joining the SRW-1 and SRPC-1
When using the optional HKSR-101 Optical Interface
Unit, refer to the HKSR-101 Installation Manual.
To mount the SRW-1 on the SRPC-1, proceed as follows.
1
Place the SRPC-1 on a flat, stable surface of a bench,
table or the like.
2
Rotate the lock lever counterclockwise (see the figure
for step
3
) until it is almost horizontal.
3
Move the assist lever to the unlock position (rotate it in
the direction of the arrow as far as it will go).
4
Grasp the top handle of the SRW-1, align the mark on
the SRW-1 with the
v mark on the SRPC-1 (see “To
release” in the following figure), and then place the
SRW-1 on the top of the SRPC-1.
Note
If the top handle is detached from the SRW-1, grasp
the side handle with one hand and mount the SRW-1
while supporting it with your other hand.
Assist lever
Lock lever
To release
To lock
SRW-1 side
SRPC-1 side
SRW-1 side
SRPC-1 side