7
Location and Function of Parts
Front Panel
a
Red tally indicator
Lights in red when this unit receives a red tally signal. You can
attach the supplied number plate here.
b
Yellow tally indicator
Lights in yellow when this unit receives a yellow tally signal.
c
Green tally indicator
Lights in green when this unit receives a green tally signal.
d
CCU number display
Displays the camera number set in the CCU menu.
e
NMI STATUS indicator or NETWORK indicator
• NMI STATUS indicator (when HKCU-IP43F is installed)
Displays the NMI-LAN status.
Green:
Normal status
Flashing green:
Network synchronization in progress
Off:
SFP+ module is not installed.
Disconnected from IP Live System Manager.
Connection with IP Live System Manager in progress
Flashing red:
Not locked to network sync signal.
Signal reception is unavailable.
• NETWORK indicator (when HKCU-4001 is installed)
Displays the GENLOCK status of the network.
Low-speed flashing:
PTP master not detected
High-speed flashing:
Genlock initiated
Lit:
Genlock achieved
Not lit:
Network genlock setting disabled
f
Status display indicator
REF IN (green):
Indicates presence of REFERENCE input
signal.
UNLOCK (Red):
Not locked to the REFERENCE input signal.
NETWORK or RCP/MSU (when HKCU-4001 is installed):
Displays the status when there is a network system
connection.
On:
When CNS MODE on the <CNS SETTINGS> page in
the NETWORK menu is set to either BRIDGE or
MCS, this indicates that external control equipment
(MSU-1000/1500 Master Setup Unit, RCP-3000/
1000 series Remote Control Panel, or other
equipment) is connected.
Flashing:
When CNS MODE on the <CNS SETTINGS>
page in the NETWORK menu is set to either BRIDGE
or MCS, this indicates that the unit cannot connect
correctly with external control equipment (MSU-1000/
1500 Master Setup Unit, RCP-3000/1000 series
Remote Control Panel, or other equipment).
Off:
When CNS MODE on the <CNS SETTINGS> page
in the NETWORK menu is set to either BRIDGE or
MCS, this indicates that a LAN cable is not connected
or that the network system connection settings have
not been configured.
When CNS MODE on the <CNS SETTINGS> page in
the NETWORK menu is set to LEGACY, this remains
turned off.
COM ERROR (Red):
Communication with the camera or
external control equipment (such as the RCP-3000/1000
series Remote Control Panel) is not possible.
FAN STOP (Red):
The fan is stopped.
1
2
3
4
qs
qd
qf
7
6
5
8
qa
0
9
