4-2 Playback Procedures
Chapter 4
Playback
4-4
(GB)
Chapter 4
Playback
In shuttle mode, the SHUTTLE dial controls the
playback speed based on the angular position of the
dial. There are seven playback speeds:
±0.03 times, ±0.12 times, ±0.5 times, ±1 times,
±2 times, ±5 times, ±21 times.
+ indicates forward direction speed, – indicates reverse
direction speed.
The SHUTTLE dial has detents at the center position,
move the SHUTTLE dial to the center indent to
display a still picture.
Use the following procedure to carry out playback in
shuttle mode.
1
Turn the SHUTTLE dial directly or press the JOG/
SHUTTLE button twice to light the SHTL
indicator.
If the SHUTTLE dial points to a position other
than the center, playback in shuttle mode starts at a
speed corresponding to the angular position of the
dial.
Pressing the JOG/SHUTTLE button toggles
between jog mode and shuttle mode.
4-2-3 Playback in Shuttle Mode
1
1,2,3
3
2
Turn the SHUTTLE dial to the angle
corresponding to the desired playback speed.
Playback in shuttle mode starts.
3
Return the SHUTTLE dial to the center indent
position or press the STOP button to cancel shuttle
mode playback.
It is possible to make pressing the JOG/SHUTTLE
button to switching between JOG and SHUTTLE
mode.
Select “KEY” in SELECTION FOR JOG/
SHUTTLE DIAL ENABLE, extended menu item
101, to enable the above feature. (This is the
default setting.)
To return to normal-speed playback
Press the PLAY button.
To alternate between normal-speed
playback and shuttle mode playback
Set the SHUTTLE dial to the position
corresponding to the desired shuttle playback
speed first. Press the PLAY button, and then press
the JOG/SHUTTLE button twice.
For intermittent shuttle mode playback, press the
STOP button first and then press the JOG/
SHUTTLE button twice.
Normally, you turn the SHUTTLE dial after setting
the jog/shuttle mode by pressing the JOG/
SHUTTLE button. You can also set the jog/shuttle
mode, however, by directly turning the dial. (This
is available when SELECTION FOR JOG/
SHUTTLE DIAL ENABLE, extended menu item
101, is set to DIAL.) In this case, you must reset
the SHUTTLE dial to the center position after
turning it, otherwise the dial is moved by vibration
and the tape may start running in the shuttle mode
during playback.
