Sony HCD-FZ900KW, Руководство по обслуживанию

Страница: 3 / 108

HCD-FZ900KW/FZ900M
3
Parts No.
Model Part No.
FZ900M: RU model 4-122-167-2
[]
FZ900KW: E3 model 4-122-167-3
[]
FZ900KW: E15 model 4-122-167-4
[]
FZ900KW: EA model 4-122-167-5
[]
FZ900KW: SP model 4-122-167-6
[]
FZ900KW: TH model 4-122-167-8
[]
FZ900KW: E32 model
4-122-168-2
[]
FZ900KW: AUS model 4-122-168-5
[]
FZ900KW: E12 model 4-122-168-6
[]
MODEL IDENTIFICATION
– Back Panel –
• Abbreviation
AUS :
Australian model
E3 : 240V AC area in E model
E12 : 220 – 240V AC area in E model
E15 : Iran model
E32 : 110 – 240V AC area in E model
EA : Saudi Arabia model
RU : Russian model
SP : Singapore model
TH : Thai model
UNLEADED SOLDER
Boards requiring use of unleaded solder are printed with the lead-
free mark (LF) indicating the solder contains no lead.
(
Caution: Some printed circuit boards may not come printed with
the lead free mark due to their particular size)
: LEAD FREE MARK
Unleaded solder has the following characteristics.
• Unleaded solder melts at a temperature about 40 °C higher
than ordinary solder.
Ordinary soldering irons can be used but the iron tip has to be
applied to the solder joint for a slightly longer time.
Soldering irons using a temperature regulator should be set to
about 350 °C.
Caution: The printed pattern (copper foil) may peel away if
the heated tip is applied for too long, so be careful!
• Strong viscosity
Unleaded solder is more viscous (sticky, less prone to fl ow)
than ordinary solder so use caution not to let solder bridges
occur such as on IC pins, etc.
• Usable with ordinary solder
It is best to use only unleaded solder but unleaded solder may
also be added to ordinary solder.
NOTES ON CHIP COMPONENT REPLACEMENT
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be dam-
aged by heat.
FLEXIBLE CIRCUIT BOARD REPAIRING
• Keep the temperature of soldering iron around 270 °C during
repairing.
• Do not touch the soldering iron on the same conductor of the
circuit board (within 3 times).
• Be careful not to apply force on the conductor when soldering
or unsoldering.
Laser component in this product is capable of emitting radiation
exceeding the limit for Class 1.
This appliance is classi fi ed as
a CLASS 1 LASER product.
This marking is located on the
rear or bottom exterior.
CAUTION
Use of controls or adjustments or performance of procedures
other than those speci
fi ed herein may result in hazardous radia-
tion exposure.