24
HCD-C700/C900
4.
LCD
Select
[4]
, insert SACD disc, and press
[ENTER]
key, and the
adjustment will be made through the following steps, then adjusted
values will be written to the EEPROM. However, if SACD disc is
not available, use the player with initial data, skipping the SACD
adjustment. In this case, you can finish the adjustment if pressing
the
x
button.
SACD Adjustment Steps
1. Sled Tilt Reset
2. Set Disc Type CD
3. LD ON
4. Spdl Start
5. Wait 500 msec
6. Focus Servo ON 0
7. Auto track Offset Adjust
8.
9. CLVA ON
10. Wait 500 msec
11. Tracking ON
12. Wait 1 sec
13. Sled ON
14. Check CLV ON
15. Auto Focus Offset Adjust
17.
18. Auto Focus Gain Adjust
19. Auto Focus Offset Adjust
20. Eq Boost Adjust
21. Auto LFO Adjust
22. Auto Track Gain Adjust
23. 32Tj Fwd
24. 32Tj Rev
25. 500Tj Fwd
26. 500Tj Rev
27. All Servo Stop */
3-11. DRIVE MANUAL OPERATION
On the Test Mode Menu screen, select
[2]
, and the manual operation
menu will be displayed. For the manual operation, each servo on/
off control and adjustment can be executed manually.
## Drive Manual Operation ##
Operation Menu
1. Disc type
2. Servo Control
3. Track/Layer Jump
4. Manual Adjustment
5. Auto Adjustment
6. Memory Check
7. Sacd Water Mark
0. Disc Check Memory
_
Exit: Return
In using the manual operation menu, take care of the following
points. These commands do not provide protection, thus requiring
correct operation. The sector address or time code field is displayed
when a disc is loaded.
1. Set correctly the disc type to be used on the Disc Type
screen.
The disc type must be set after a disc was loaded.
The set disc type is cleared when the tray is opened.
2. After power ON, if the Drive Manual Operation was
selected, first perform “Reset SLED TILT” by opening 1.
Disc Type screen.
3. In case of an alarm, immediately press the
x
button to
stop the servo operation, and turn the power OFF.
Basic operation (controllable from front panel or remote
commander)
[POWER]
Power OFF
x
Servo stop
[OPEN/CLOSE]
Stop+Eject/Loading
[RETURN]
Return to Operation Menu or Test Mode
Menu
[NEXT]
,
[PREV]
Transition between sub modes of menu
[1]
to
[9]
,
[0]
Selection of menu items
Cursor UP/DOWN
Increase/Decrease in manually adjusted
value
Содержание HCD-C700 - Tuner Cd Player
Страница 47: ...47 47 HCD C700 C900 5 14 SCHEMATIC DIAGRAM DVD SECTION 9 9 84 83 ...
Страница 58: ...58 58 HCD C700 C900 5 25 SCHEMATIC DIAGRAM SW SECTION ...
Страница 61: ...61 61 HCD C700 C900 5 28 PRINTED WIRING BOARD POWER SECTION SIDE A See page 30 for Circuit Boards Location ...
Страница 109: ...109 HCD C700 C900 MEMO ...