Sony HAP-Z1ES, Руководство пользователя

Страница: 140 / 206

A list of settings appears.
9. Select a setting you want to configure.
10. Select [In use].
Select [Not in use] for items you do not want to set.
11. Select [Next].
12. Select [Test].
Select [Exit] if you do not want to test.
13. Confirm the instructions on the screen and then select [Start].
The connection test starts.
14. When you have confirmed that no problems have been found in the test, select [Exit].
Note
If the HDD AUDIO PLAYER is turned off or in standby mode, you cannot adjust the volume or mute the amplifier
using the remote control supplied with the HDD AUDIO PLAYER.
Hint
You can also configure settings so that they are not controlled by the remote control, such as when you want to turn
the power of the HDD AUDIO PLAYER off but do not want to turn the amplifier off.
If you operate the connected amplifier using the remote control supplied with the HDD AUDIO PLAYER, operation of
the amplifier may become inconsistent (operating at times but not operating at other times) due to interference of the
remote control signal, especially if you continuously control the volume.
For example, if the infrared signal from the supplied remote control directly enters the remote sensor (receiver) of the
connected amplifier, interference may occur with the signal input from the IR input jack of the amplifier or the signal
output from the installed IR blaster. This causes the amplifier to fail to receive the correct signal, resulting in
inconsistent response from the amplifier.
In this case, place the amplifier in a location where it will not be affected by the infrared signal of the remote control of
the HDD AUDIO PLAYER.
It is recommended that you use HDD Audio Remote, to avoid interference problems.
Notes on use
4-472-856-11(1)
Copyright 2013 Sony Corporation
140