GB
O
thers/I
nde
x
When the camcorder is connected to
a computer or accessories
Do not try to format the recording media of the
camcorder with a computer. If you do so, your
camcorder may not operate correctly.
When connecting the camcorder to another
device with communication cables, be sure to
insert the connector plug in the correct way.
Pushing the plug forcibly into the terminal
will damage the terminal and may result in a
malfunction of the camcorder.
When the camcorder is connected to other
devices through a USB connection and the
power of the camcorder is turned on, do not
close the LCD panel. The image data that has
been recorded may be lost.
Notes on optional accessories
We recommend using genuine Sony accessories.
Genuine Sony accessories may not be available
in some countries/regions.
Multi interface shoe
When using a dedicated microphone or
portable speaker, their power turns on or off
according to the power of your camcorder.
Refer to the operating instructions supplied
with the accessory used for details.
To attach an accessory, insert and fix the
accessory to the Multi interface shoe by pressing
down and sliding until it stops.
When you are recording movies with an
external flash (sold separately) connected to
the accessory shoe, turn off the power of the
external flash to prevent charging noise from
being recorded.
You cannot use an external flash (sold
separately) and the built-in flash at the same
time.
When an external microphone (sold separately)
is connected, it takes precedence over the built-
in microphone.
On Wireless Remote Commander
Remove the insulation sheet before using the
Wireless Remote Commander.
Point the Wireless Remote Commander
towards the remote sensor to operate your
camcorder (p. 14).
When no commands have been sent from the
Wireless Remote Commander within a certain
period, the light blue frame disappears. When
you press any of
/
/
/
, or ENTER again,
the frame appears at the position where it was
displayed last displayed.
You cannot select some buttons on the LCD
screen, or the viewfinder using
/
/
/
.
To change the battery of the Wireless Remote
Commander
While pressing on the tab, inset your fingernail
into the slit to pull out the battery case.
Place a new battery with the + side facing up.
Insert the battery case back into the Wireless
Remote Commander until it clicks.
WARNING
Battery may explode if mistreated. Do not
recharge, disassemble or dispose of in fire.
When the lithium battery becomes weak, the
operating distance of the Wireless Remote
Commander may shorten, or the Wireless
Remote Commander may not function
properly. In this case, replace the battery with
a Sony CR2025 lithium battery. Use of another
battery may present a risk of fire or explosion.
Insulation sheet
Tab
