185
Troubleshooting
Поиск и устранение неисправностей
If you run into any problem using your camcorder, use the following table to troubleshoot the
problem. If the problem persists, disconnect the power source and contact your Sony dealer or
local authorized Sony service facility. If “C:
ss
:
ss
” appears on the screen or the display
window, the self-diagnosis display function has worked. See page 190.
In the recording mode
Symptom
Cause and/or Corrective Actions
• The POWER switch is not set to CAMERA.
c
Set it to CAMERA. (p. 26)
• The tape has run out.
c
Rewind the tape or insert a new one. (p. 24, 39)
• The write-protect tab is set to expose the red mark.
c
Use a new tape or slide the tab. (p. 24, 25)
• The tape is stuck to the drum (moisture condensation).
c
Remove the cassette and leave your camcorder for at
least 1 hour to acclimatize. (p. 204)
• While being operated in CAMERA mode, your camcorder
has been in the standby mode for more than 3 minutes.
c
Set the POWER switch to OFF (CHG) and then to
CAMERA again. (p. 26)
• The battery pack is dead or nearly dead.
c
Install a fully charged battery pack. (p. 15, 16)
• The viewfinder lens is not adjusted.
c
Adjust the viewfinder lens. (p. 30)
• STEADYSHOT is set to OFF in the menu settings.
c
Set it to ON. (p. 107)
• FOCUS is set to MANUAL.
c
Set it to AUTO. (p. 65)
• Shooting conditions are not suitable for autofocus.
c
Set FOCUS to MANUAL to focus manually. (p. 65)
• The LCD panel is open.
c
Close the LCD panel. (p. 28)
• The tape is the standard 8 tape.
c
Use Hi8
/Digital8 tapes. (p. 114)
• The contrast between the subject and background is too
high. This is not a malfunction.
• This is not a malfunction.
• Slow shutter, low lux or Super NightShot mode is
activated. This is not a malfunction.
A vertical band appears when you
shoot a very bright subject.
Some tiny white spots appear on the
screen.
A vertical band appears when you
shoot a subject such as lights or a
candle flame against a dark
background.
START/STOP does not operate.
The power goes off.
The image on the viewfinder screen
is not clear.
The autofocusing function does not
work.
The SteadyShot function does not
work.
The picture does not appear in the
viewfinder.
You cannot record in the LP mode.
— Troubleshooting —
English
Types of trouble and their solutions
(Continued on the following page)
Содержание Handycam DCR-TRV730E
Страница 232: ...Sony Corporation Printed in Japan ...