Sony GDM-20D11, Руководство по установке

Страница: 5 / 8

Running the monitor on regular video cards:
This monitor requires a special video card to run all the lower resolution
modes properly on a PC. Higher resolutions work just fine depending on the
limitations of your video card.
(mention that you want -81 Khz setting). We recommend
www.mirage-
mmc.com to support all the low resolution and high resolution modes.
You can run this monitor on normal video cards with the monitor specification
using the MIRAGE LOCK device. In this case you must connect the Mirage
LOCK to the cable and then connect it to this monitor. You must also use a
high resolution mode and refresh rate. This monitor will not work in DOS, Safe
mode or 640x480 without the MIRAGE video card.
We recommend that you use your existing system and previous monitor to change the
display settings to one of the high resolutions mentioned below. Please make sure that you
also change your monitor type to one which supports higher refresh rates like the Sony
G500 Multiscan monitor mentioned below. Then switch to 1280x1204 60 hz mode on your
previous monitor and make sure that the picture is ok (some small monitors may not be
able to run high resolution and high refresh rates, so if you could not see a recognizable
picture, go back to your previous mode). Once the picture is ok, without rebooting and
without turning your system off, switch the monitors and connect this monitor. You should
get a stable picture on this monitor now.
You may want to go to a different resolutions or higher refresh rates. Windows will switch
to the new mode and asks you to confirm the new mode within 15 seconds. If you can not
see the new mode and do not respond within the 15 seconds, the screen will go back to the
previous mode.
Important Hint: When changing resolutions and refresh rates, change one at a time. For
example to get 1024x768 @85 hz which we recommend on this monitor, first change to
1024x768 resolution. Hit Apply, then change the refresh rate to 85 Hz and hit Apply again.
Try using the following resolutions and refresh rates:
800x600 @ 100 Hz
1024x768 @75, 85, 100 Hz (* recommended mode)
1124x864 @75, 85, 100 Hz (* recommended mode)
1280x1024 @60, 70 Hz
1600x1200 @60 Hz
Also we recommend -,- (negative polarity) for the modes you require to run.
Standard 1280x1024 @60 Hz uses -,- polarity for example.