Sony DWZ-B50GB, Руководство по эксплуатации

Страница: 25 / 31

25 Troubleshooting
The sound is
distorted. The attenuation level of the
transmitter is too low. The audio input level is too high.
Set the attenuation level on the
transmitter to a level where sound
is not distorted.
The transmitter is set to MIC
input. The audio input level is too high.
Specify INST input.
The output level of the
receiver does not match the
input level setting of the
connected device. Set the MIC/LINE selector
according to the input level of the
connected device. (ZRX-HR50)
Noise occurs. The transmitter and receiver
are far away from each other. Shorten the distance between the
transmitter and receiver until
audio breakup does not occur.
Signal interference from
other devices is occurring. Change the selected channel, or
move the devices that are causing
interference away from the unit.
Two or more transmitters are
set to the same channel. Do not use the same channel for
more than one transmitter.
[Wide Band] and [Narrow
Band] are being used
simultaneously. When using multiple channels
simultaneously, use channels
from a single RF mode, either
[Wide Band] or [Narrow Band].
The service area
(i.e., operating
range) is small. The antenna is not attached
to the receiver. Attach the supplied antenna.
The antenna is being
squeezed. Remove your hands from the
antenna.
The audio quality is
abnormal. The equalizer setting is
incorrect. Set the equalizer setting to 0.
(ZRX-HR50)
The unit does not
turn off when the
POWER switch is
pressed. Button operations are locked. Set the button lock switch to
UNLOCK.
The RF mode is being
configured. The unit cannot be turned off
while RF mode configuration is in
progress. Press and hold the
channel selection button to end
configuration before turning off
the unit. (ZTX-B01)
Channels cannot be
changed. Button operations are locked. Set the button lock switch to
UNLOCK.
The settings menu is not
open. Follow the instructions in
“Displaying the settings menu”
and “Configuring the receiving
channel settings” (page 14) to
configure settings. (ZRX-HR50)
Symptom Meanings Remedy