Sony DWT-B01, Руководство по эксплуатации

Страница: 33 / 44

33 Setting menus
the SET button, turn the power on. Then
change the setting after the signal
transmission has stopped.
Setting the RF Output
Power
(RF POWER)
You can set the RF output power.
1 mW (LOW): transmitted by 1 mW
10 mW (MID):
transmitted by 10 mW
50 mW (HIGH): transmitted by 50 mW
Using wireless remote control, this function
can be controlled from the receiver and
other devices.
The setting for this function cannot be
changed during actual signal transmission.
To change the setting, turn off the
transmitter first. Then, while holding down
the SET button, turn the power on. And
then, change the setting after the signal
transmission has stopped.
Setting the audio input
level
(INPUT LEVEL)
You can set the input level to an analog
head amp.
Select LINE or MIC, depending on the
audio source connected to the audio input
connecter.
When MIC is selected, the ATT
(attenuation) level will flash next. With the
microphone connected, speak into the
microphone as you monitor the input level
meter and press the + or – button repeatedly
to select the appropriate attenuation level.
The reference levels for the various settings
are as follows:
With the wireless remote control function, the attenuation level can be changed from the
receiver and other devices.
Low-cut filter setting
(LCF)
The frequency of the low-cut filter can be
set.
OFF: Turns off the low-cut filter.
20 30 40 50 60 70 80 90 100
120 140 160 180 200 220 (Hz):
Low-cut filter is set according to the
selected frequency.
Note
Input Attenuation
(dB) Reference input
level (dB) Maximum input
level (dBu) Headroom (dB)
MIC 0 –58 –22 36
3 –
55
–19
6 – 52 –16
9 –
49
–13
3 dB step 3 dB step 3 dB step
45
– 13
+23
48 – 10 +24 34
LINE
–
+4 +24 20