30
For details, see “Sensitivity Setting for Received Signal
Quality Alert (QL ALERT SENS)” (page 30).
Excess peak level for audio input
(AF PEAK)
Specifies whether to display a warning via the ALERT
indicator when the audio input has been detected as
exceeding the peak level.
ON/OFF
Low transmitter battery
(TX BATTERY LOW)
Specifies whether to display a warning via the ALERT
indicator when the remaining battery of the transmitter is
detected as low.
ON/OFF
Encryption mismatch
(ENCRYPTION UNMATCH)
Specifies whether to display a warning via the ALERT
indicator when a mismatch between the encrypted
communication settings for the transmitter and the
receiver is detected.
ON/OFF
Unsynchronized with external sync signal
(EXTERNAL WORD SYNC UNLOCK)
Specifies whether to display a warning via the ALERT
indicator when synchronization with the external sync
signal (word clock) is not possible.
ON/OFF
Audio codec mode mismatch
(CODEC MODE
UNMATCH)
Specifies whether to display a warning via the ALERT
indicator when an audio codec mode mismatch is
detected between the transmitter and receiver.
ON/OFF
Sensitivity Setting for Received
Signal Quality Alert
(QL ALERT SENS)
Specifies the level at which the quality of the received
signal is determined to be low.
HIGH:
The quality is determined to be low when the QL
meter displays 4 bars or less.
MID:
The quality is determined to be low when the QL
meter displays 2 bars or less.
LOW:
The quality is determined to be low when the QL
meter displays 1 bar or less.
If QL LOW is set to OFF in the ALERT FUNCTION
submenu, the ALERT indicator will not light even is the
quality of the received signal is low.
For details, see “Low receiving signal quality (QL
LOW)” (page 29).
Items Related to Display (DISPLAY
submenu)
Setting the brightness of the display
(BRIGHTNESS)
Ten levels of brightness can be selected for the organic
light-emitting diode display.
The selectable settings are the following:
(Dark)
1 2 3 4 5 6 7 8 9 10
(Bright)
Automatic dimming of the display
(DIMMER
MODE)
The organic light-emitting diode display can be set to dim
or turn off after a certain amount of time.
AUTO OFF:
The display turns off after 30 seconds. The
display becomes bright again when you use any button/
control.
AUTO DIMMER:
The display dims after 30 seconds.
The display becomes bright again when you use any
button/control.
ALWAYS ON:
The display stays on at the brightness
level set with the BRIGHTNESS function.
Locking the Unit Settings
(SETTING
LOCK)
UNLOCK:
Settings can be changed.
LOCK:
Settings are locked.
You can check menu settings even though they are
locked. You can also use the MONITOR button and
headphone volume control.
Settings Memory Function
(USER
MEMORY)
Various settings are stored on the unit, and settings can
also loaded into the unit.
Executing SAVE stores settings, and executing LOAD
loads settings.
The menu items that can be stored/loaded are RECEIVER
menu, RF REMOTE menu, and UTILITY menu items.
Resetting Parameters to Their
Factory Settings
(FACTORY PRESET)
All parameter settings can be returned to their factory
settings.
A message appears asking for confirmation. Rotate the
jog dial to select YES. The receiver parameters are reset
to their factory settings.
Note
Note
