Sony DWM-01, Руководство по эксплуатации

Страница: 21 / 39

21 Using the Wireless Remote Control Function
1
Set the receiver to be used for
controlling the microphone to pairing
mode.
For details, refer to the operating instructions
supplied with the receiver.
2
Press the + or – button repeatedly until
the RF REMOTE indication is
displayed.
3
Hold down the SET button until the
item to be set flashes.
4
Press the + or – button repeatedly to
select PAIRING.
5
Press the SET button to enter.
The microphone sends a pairing
request to the receiver which is on
pairing mode.
Before established pairing, if you press
any operation key on the microphone,
pairing mode will be cancelled.
When pairing has been established, the
wireless remote control condition level
(indicated by
) goes up, RF
REMOTE turns on, and the remote
control function becomes operative.
When “Pairing fail” is
displayed
• Successful communication between the
microphone and the receiver did not
occur within a given amount of time.
Perform pairing again.
• Pairing has been performed with the grip
open. When the internal antenna is
covered with the grip, pairing may not be
carried out. After setting the microphone
ready for pairing in step
5 above, be sure
to close the grip.
To use the wireless remote
control function with a
previous pairing
In the RF REMOTE indication, select ON.
• When you set RF REMOTE to ON, the
microphone will communicate with the
receiver to which it was previously
paired. To use the wireless remote
control function with another receiver,
you must perform the pairing procedure
for that receiver.
• Multiple microphones/transmitters
cannot be paired with the same receiver.
• If you reset all parameters by using the
FACTORY PRESET function (see page
30) , the pairing setting of the microphone
is also cleared.
The following microphone settings
can be done from the wireless
remote control:
• Frequency band/group/channel selection
• RF transmission power setting
• Attenuator for the audio input setting
• Low-cut filter setting
• Power save setting
For details on menu operation, see “Setting Menus”
on page 26.
To cancel the wireless remote
control function
In the RF REMOTE indication, select OFF.
Notes on the wireless remote
control function
The wireless remote control function on the
microphone uses the 2.4-GHz band and
may thus be subject to interference from
other devices.
• When pairing fails (“Pairing fail” is
displayed), successful communication
Notes