Chapter 1 Overview
24
Chapter 1
Overview
Location and Function of Parts
8
Fitting for optional microphone holder
You can fit an optional CAC-12 Microphone Holder
here. (See page 37.)
9
Video light connector
A video light with a maximum power consumption of
30 W such as the Anton Bauer Ultralight 2 or
equivalent can be connected.
0
LENS connector (12-pin)
If you use a lens with cable, connect the lens cable.
qa
VIDEO OUT connector (BNC)
This outputs the video signal captured by the
camcorder.
qs
REMOTE connector 2 (10-pin)
Connect the optional RM-M7G Remote Control Unit
to this connector. Set the CAMERA SELECT switch
on the bottom of RM-M7G to 1.
You can also connect the RM-VJ1 Remote Control
Unit (equipped with microphone and monitor.)
Notes
• EZ mode cannot be used if the RM-M7G is
connected to the camcorder.
• Be sure to turn off the power of the camcorder before
connecting the RM-M7G/VJ1.
• Be sure to turn off the power of the camcorder before
disconnecting the equipment connected to this
connector. Otherwise, the camcorder will not work
properly.
Rear section
1
Cassette holder
Power the camcorder and press the EJECT button to
open the lid. Insert the cassette and close the lid by
pressing the indication “PUSH” .
2
GEN LOCK IN (gen lock video input)/VIDEO
IN (video input) connector (BNC)
GEN LOCK IN: When synchronizing the camcorder
to an external signal, input a reference videos
ignal (VBS or BS). (See page 84.)
1
Cassette holder
2
GEN LOCK IN/VIDEO IN connector
a)
3
TC IN connector
4
TC OUT connector
5
S VIDEO OUT connector
6
MONITOR OUT connector
7
AUDIO OUT CH-1/CH-2 connectors
VIDEO IN: When the optional DSBK-501/501P
Analog Composite Input Board is fitted to the
camcorder, you can input the analog video signals
(VBS) to this connector.
3
TC IN (time code input) connector (BNC)
Input an external signal for synchronizing the built-in
time code generator. Use an SMPTE (DSR-300A) or
EBU (DSR-300AP) time code signal.
a) When the optional DSBK-501/501P is fitted
