13
GB
Subwoofer direct connection
You can use a subwoofer without a power amplifier
when it is connected to a rear speaker lead.
To enable the connection, set [SUBW MODE] in
[SUBW DIRECT] to [1] to [3].
Note
Use a subwoofer with a 2 Ω impedance or 4 Ω to 8 Ω
impedance, and with adequate power handling
capacities to avoid damage.
Speaker connection for high volume
playback
For high volume playback, you can connect front
speaker in parallel.
For this connection:
– Set [SPKR LOAD] in [GENERAL] to [2 OHM].
– Connect the subwoofers to right and left rear
speaker leads or use a dual voice coil subwoofer
with 4 Ω to 8 Ω impedance.
Notes
When using a subwoofer with dual voice coil, or using
subwoofer(s) by connecting to the right and left rear
speaker leads, be sure to set [SPKR LOAD] in
[GENERAL] to [2 OHM].
To exert the speaker’s potential, make the power
connection to the battery directly (page 12).
To capture your voice during handsfree calling, you
need to install the microphone
.
Cautions
It is extremely dangerous if the cord becomes
wound around the steering column or gearstick.
Be sure to keep it and other parts from interfering
with your driving operations.
If airbags or any other shock-absorbing
equipment is in your car, contact the store where
you purchased this unit, or the car dealer, before
installation.
Notes
When mounting on the dashboard, remove the visor
clip carefully from the microphone
, then attach the
flat-mount base
to the microphone
.
Before attaching the double-sided tape
, clean the
surface of the dashboard with a dry cloth.
Front speaker
Subwoofer
FL
FR
RR
RL
Front speaker
(4 Ω to 8 Ω)
Rear speaker
(4 Ω to 8 Ω)
Subwoofer
(4 Ω to 8 Ω, dual voice
coil type)
Installing the microphone
Clip (not supplied)
