78
Dubbing only desired scenes – Digital program editing (on tape)
Step 2: Setting the VCR to operate
To connect using the A/V connecting cable, send the control signal by infrared rays to
the remote sensor on the VCR.
The POWER switch should be set to
.
Operate by touching the panel.
(
1
)
Turn the power of the connected VCR on.
If the VCR has an input selector, set it to input mode.
When you connect a video camera recorder, set its power switch to VCR/
VTR.
(
2
)
Press FN to display PAGE1.
(
3
)
Press MENU to display the menu.
(
4
)
Select VIDEO EDIT in
, then press EXEC (p. 177).
(
5
)
Select TAPE, then press EXEC.
(
6
)
Press EDIT SET.
(
7
)
Select CONTROL, then press EXEC.
(
8
)
When connecting with the A/V connecting cable, select IR, then press EXEC.
When connecting with the i.LINK cable, select i.LINK, press EXEC, then go to
“Step 3: Adjusting the synchronization of the VCR” on page 81.
(
9
)
Select IR SETUP, then press EXEC.
(
10
)
Select the IR SETUP code of your VCR, then press EXEC. Check the code in
“About the IR SETUP code” (p. 80).
4
5
7
9
6
V I DEO ED I T
ED I T SET
CONTROL
ADJ TEST
”CUT - I N”
”CUT -OUT”
I R SETUP
PAUSEMODE
I R TEST
END
RET.
EXEC
I R
V I DEO ED I T
ED I T SET
CONTROL
ADJ TEST
”CUT - I N”
”CUT -OUT”
I R SETUP
PAUSEMODE
I R TEST
RET.
EXEC
3
V I DEO ED I T
ED I T SET
CONTROL
ADJ TEST
”CUT - I N”
”CUT -OUT”
I R SETUP
PAUSEMODE
I R TEST
RET.
EXEC
I R
i. L I NK
END
END
0:32:30:14
TOTAL
SCENE
0:00:00:00
0
V I DEO ED I T
MARK
I N
START
ED I T
SET
UNDO
END
OTHERS
DATA CODE
BEEP
COMMANDER
D I SPL AY
V I DEO ED I T
EXIT
RET.
EXEC
RETURN
TAPE
MEMORY