1-4E
DSC-S60/S80/S90/ST80
1-6. PROCESS AFTER FIXING FLASH ERROR
When “FLASH error” (Self-diagnosis Code E : 91 : ** ) occurs, to prevent any abnormal situation caused by high voltage, setting of the
flash is changed automatically to disabling charge and flash setting.
After fixing, this setting needs to be deactivated. Flash error code can be initialized by the operations on the Setup screen.
Method for Initializing the Flash Error Code
Initializes the setting to the default setting.
1
Select [OK] with
v
on the control button, then press
z
.
The message “Initialize all settings Ready?” appears.
2
Select [OK] with
v
, then press
z
.
The settings are reset to the default setting.
•
Make sure that the power is not disconnected during resetting.
Initialize
OK
See the following procedure.
Cancel
Cancels the resetting.
1-7. LCD TYPE CHECK
SH
CA
LCD panel
Width of Flexible Harness of LCD Panel
Rear View (when the rear cabinet assy is removed.)
SW-446 Board (Side B)
Narrow:
TYPE C
Wide: TYPE S
Mounted Parts
TYPE C
TYPE S
D004
—
Mount
D006
Mount
—
SH
CA
D004
D006
The LCD type can be discriminated with the mounted parts on the SW-446 board, or the width of flexible harness of LCD panel.
Note:
About SW-446 board and LCD panel, discriminate LCD type on the machine, and replace the same type.
Checking method:
1)
Refer to “SECTION 2 DISASSEMBLY” to remove the rear cabinet assy.
2)
Referring the following figures, each type is discriminated with the mounted parts on the SW-446 board, or the width of flexible cable
of LCD panel.
Model
DSC-S60
DSC-S80
DSC-S90
DSC-ST80
LCD type
TYPE C
TYPE C
TYPE C or TYPE S
TYPE C
