DSC-P200
2-7
2-8
2-3. EXCHANGE METHOD OF BARRIER ASSY
Service parts
Part Number
Part Name
Quantity
1
3-091-427-01
Ring (A), Ornamental
1
2
X-3954-476-1
Barrier Assy
1
3
3-086-156-31
Tapping screw (P2)
2
Tools used
Torque driver
Soldering iron
Weight about 60g
Adhesive (Super X) (Note)
Note:
Use adhesive (Super X) or an equivalent article.
Don’t use what becomes white after drying like a quick-drying glue.
2-3-1. PEEL OFF OLD ORNAMENTAL RING A
The Ornamental Ring A has adhered to the Barrier Assy strongly and accordingly, use a soldering iron to weaken the adhesive force.
Heat four circled portions with the soldering iron.
Heating temperature is about 300ºC.
Beware of a burn since the entire Ornamental Ring becomes hot.
*
As the adhesive force of Ornamental Ring A is considerably large, the forced peeling will damage the group-1 frame.
Insert the tip of tweezers, etc. into a notch of the group-1 frame and prize the ring.
*
Take extreme care so as not to damage the coated surface of the group-1 frame.
In case of difficult peeling, heat the ring again with the soldering iron.
If this re-heating failed, it may be advisable that the ring be peeled while heating the portions
1
→
2
→
3
→
4
in the under figure one
by one sequentially.
*
Discard the removed Ornamental Ring A.
1
2
3
1
Tip
3
4
2
2-3-2. REMOVE OLD BARRIER ASSY
1
Remove two screws.
*
Discard the removed screws.
2
Remove the Barrier Assy.
*
Discard the removed Barrier Assy.
*
After removing the Barrier Assy, if the “G1 Dust-Proof Ring” was removed, it must be returned to the home position.
In returning the ring, adjust the location of a projection to the lens direction.
This is an important part to prevent the dust and light from coming in.
*
After removing the Barrier Assy, take extreme care not to drop dust or foreign substances in the lens barrel.
2-3-3. INSTALL NEW BARRIER ASSY
1
Install new Barrier Assy by paying attention to the projection of the Barrier Assy in relation to the position shown in the under figure.
2
Tighten two screws.
*
Tightening torque = 0.5 kgf (4.9 N)
1
1
2
Projection
2
2
1
Содержание CSS-PHB - Cybershot Station For DSCP200 Digital Cameras
Страница 22: ...DSC P200 Schematic diagrams of the CH 146 SY 123 boards are not shown Pages from 4 9 to 4 28 are not shown ...
Страница 28: ...DSC P200 Printed wiring boards of the CH 146 SY 123 boards are not shown Pages from 4 39 to 4 42 are not shown ...
Страница 30: ...DSC P200 Waveforms of the SY 123 board are not shown Pages 4 45 and 4 46 are not shown ...
Страница 32: ...DSC P200 Mounted parts location of the CH 146 and SY 123 boards are not shown Page 4 48 and 4 49 are not shown ...
