Sony CMT-DH3, Руководство по эксплуатации

Страница: 94 / 112

CMT-DH3.GB.3-097-194-11(1)
GB
On heat buildup
 Heat buildup on the unit during operation is
normal and is not cause for alarm.
 Do not touch the cabinet if it has been used
continuously at a high volume because the
cabinet may have become hot.

Do not obstruct the ventilation holes.
On the speaker system
The front speaker is magnetically shielded and
can be installed near a TV. Color irregularity
may still be observed, however on some types
of TV screens. In this situation, turn off the
TV, wait 15 to 30 minutes, and turn it back
on. Place the right speaker on the right side of
the unit and the left speaker on the left side of
the unit. If there is no improvement, move the
speakers far away from the TV.
IMPORTANT NOTICE
Caution: If you leave a still video image
or on-screen display image displayed on
your TV for an extended period of time via
this system, you risk permanent damage
to your TV screen. Projection TVs are
especially susceptible to this.
Cleaning the cabinet
Clean this system with a soft cloth slightly
moistened with a mild detergent solution.
Do not use any type of abrasive pad, scouring
powder, or solvent, such as thinner, benzine,
or alcohol.
Specifications
Main unit
Amplifier section
DIN power output (rated)
40 W + 40 W (6 ohms at 1 kHz, DIN)
Continuous RMS power output (reference)
50 W + 50 W (6 ohms at 1 kHz, 10%
THD)
Inputs:
AUDIO IN (stereo mini jack):
Voltage 620 mV, impedance
47 kilohms
MIC (mini jack):
Sensitivity 0.8 mV, impedance
10 kilohms
(USB) port:
Type A, maximum current 500 mA
Outputs:
DIGITAL OUT (square optical connector
jack):
Wavelength 660 nm
VIDEO OUT (phono jack):
Max. output level 1 Vp-p, unbalanced,
Sync. negative load impedance
75 ohms
COMPONENT VIDEO OUT:
Y: 1 Vp-p, 75 ohms
Pb/Cb: 0.7 Vp-p, 75 ohms
Pr/Cr: 0.7 Vp-p, 75 ohms
S VIDEO OUT (4-pin/mini-DIN jack):
Y: 1 Vp-p, unbalanced, Sync. negative
C: 0.286 Vp-p, load impedance
75 ohms
PHONES (stereo mini jack):
accepts headphones of 8 ohms or
more