11
Setting DSO 3D and I-TA
1
Press
(SOUND)
repeatedly to select
your desired item during playback.
The items change as follows:
DSO 3D
t
I-TA
t
Balance
t
Fader
t
Sub Woofer
2
Rotate the volume control dial to
select the setting.
After about 3 seconds, the setting is complete.
With the card remote commander
In step 2: press
<
or
,
to adjust tuning DSO 3D and
I-TA precisely. See page 12 for further information.
Setting BBE MP
1
Press
(BBE MP)
.
2
Select “ON.”
After about 3 seconds, the setting is complete
and the display returns to normal play/
reception mode.
Optimizing your sound
— Sound MENU
You can precisely optimize the setting of HDEQ,
DSO 3D and I-TA to your taste and according to
your car interior, using the Sound MENU. See
also “Precisely adjusting your sound” (page 13).
The menu method is common to each feature -
learn the procedure below, then proceed to each
feature.
1
Press
(MENU)
during playback.
2
Press
(GP/ALBM)
+/– repeatedly until
“SOUND” appears.
3
Press
(ENTER)
.
4
Press
(GP/ALBM)
+/– repeatedly to
select an item, then press
(ENTER)
.
5
Repeat step 4 to adjust other items.
6
Press
(MENU)
.
The setting is complete.
With the card remote commander
In steps 2 and 4: press
M
or
m
to adjust the selected
item.
HDEQ Tuning
The equalizer curve is precisely adjustable for
frequency and volume level. Tuning consists of 4
channels: Front L/R and Rear L/R.
1
Select “SOUND”
t
“HDEQ” in MENU
mode.
2
Select “Custom1,” “Custom2” or
“Custom3” to store.
3
Select the equalizer curve you wish to
adjust.
In your chosen Custom setting the equalizer
curve can be adjusted, then a pencil icon will
appear as “Custom1”
t
“Custom1
.”
4
Select the speaker to adjust.
5
Adjust the equalizer curve to your
taste.
1
Press
(SEEK)
–/+ repeatedly to select the
frequency you wish to adjust (adjustable
from 63 Hz to 16 kHz in 13 bands).
2
Press
(GP/ALBM)
+/– to adjust the level of
the chosen frequency (1 dB steps from –6
dB to +6 dB).
3
Repeat steps
1
and
2
to adjust other
bands of the equalizer curve.
6
Confirm your settings using the
confirmation screen, and save the
value.
7
Repeat steps 3 to 6 until all the
speakers have been set.
Note
The pencil icon appears only after selecting the preset
in step 3, however, until it is saved in step 6, the
adjustment will not be applied.
Tip
Select “Reset” in step 4 to reset the default setting
(Flat).
With the card remote commander
In
1
of step 5: press
<
or
,
to adjust the
frequency; in step
2
: press
M
or
m
to adjust the level.
continue to next page
t
