Sony CDX-GT240, Руководство по обслуживанию

Страница: 4 / 40

CDX-GT24W/GT240/GT290/GT290S
4
SECTION 1
SERVICING NOTES
EXTENSION CABLE AND SERVICE POSITION
When repairing or servicing this set, connect the jig (extension
cable) as shown below.
• Connect the MAIN board (CNP301) and the SERVO board
(CN401) with the extension cable (Part No. J-2502-076-1).
NOTE FOR REPLACEMENT OF THE AUX JACK (J901)
To replace the AUX jack requires alignment.
1. Insert the AUX jack into the KEY board.
2. Place the KEY board on the front panel.
3. Solder the three terminals of the jack.
NOTE FOR REPLACEMENT OF THE SERVO BOARD
When repairing, the complete SERVO board (Part No. A-1552-
122-A) should be replaced since any parts in the SERVO board
cannot be repaired.
NOTE FOR THE 15-PIN CONNECTOR (CN901)
Do not use alcohol to clean the 15-pin connector (CN901) connect-
ing the front panel with the main body.
Do not touch the connector directly with your bare hand. Poor con-
tact may be caused.
SERVO BOARD
CN401
MAIN BOARD
CNP301
J-2502-076-1
KEY board
AUX jack
front panel