20
Adjusting the sound
characteristics
You can adjust the balance, fader, low pass filter
and subwoofer volume.
1
Press
(SEL)
repeatedly until “BAL,”
“FAD,” “LPF” or “SUB” appears.
Each time you press
(SEL)
, the item changes
as follows:
LOW
*
1
t
MID
*
1
t
HI
*
1
t
BAL (left-right)
t
FAD (front-rear)
t
LPF (low pass filter)
*
2
*
3
t
SUB (subwoofer volume)
*
2
*
4
*1
When EQ3 is activated (page 21).
*2
When “SUB” is selected (page 20).
*3
The cut off frequency is adjustable to 78 Hz,
125 Hz, or OFF.
*4
The volume level is adjustable between –10
and +10 steps. (Below –10, “ATT” is displayed.)
2
Press the /– button to adjust
the selected item.
Note
Adjust within 3 seconds after selecting the item.
Quickly attenuating the
sound
Press
(ATT)
.
After “ATT-ON” momentarily appears,
“ATT” appears in the display.
To restore the previous volume level, press
(ATT)
again.
Tip
When the interface cable of a car telephone is
connected to the ATT lead, the unit decreases the
volume automatically when a telephone call comes in
(Telephone ATT function).
Changing the sound and
display settings
The following items can be set:
• REAR/SUB*
1
— to switch the audio output
REAR or SUB.
– Select “REAR” to output to a power
amplifier.
– Select “SUB” to output to a subwoofer.
• A.SCRL (Auto Scroll)*
2
(page 12).
• M.DSPL (Motion Display) — to turn the
motion display on or off.
– Select “ON” to activate the motion display
(the moving pattern appears in the display).
– Select “OFF” to deactivate the motion
display.
• DEMO*
1
— to turn the demonstration display
on or off.
– Select “ON” to activate the demonstration
display (the demonstration starts about 10
seconds after the unit is turned off).
– Select “OFF” to deactivate the
demonstration display.
• BEEP*
3
— to turn the beeps on or off.
• DIM — to change the brightness of the display.
– Select “ON” to dim the display.
– Select “OFF” to deactivate the Dimmer.