8
Receiving the memorised
stations
1
Press
(SOURCE)
repeatedly to select the
tuner.
2
Press
(MODE)
repeatedly to select the
band.
3
Press the number button (
(1)
to
(6)
) on
which the desired station is stored.
If you cannot tune in a preset
station
Press either side of
(SEEK/AMS)
to search
for the station (automatic tuning).
Scanning stops when the unit receives a
station. Press either side of
(SEEK/AMS)
repeatedly until the desired station is
received.
Note
If the automatic tuning stops too frequently, press
(SENS/BTM)
repeatedly until “LOCAL” (local seek
mode) is displayed. Only the stations with
relatively strong signals will be tuned in.
Tip
If you know the frequency of the station you want
to listen to, press and hold either side of
(SEEK/AMS)
to locate the frequency
approximately, then press
(SEEK/AMS)
repeatedly
to fine adjust to the desired frequency (manual
tuning).
If FM stereo reception is poor
— Monaural Mode
Press
(SENS/BTM)
repeatedly until
“MONO” appears.
The sound improves, but becomes
monaural (“STEREO” disappears).
To return to normal mode, press again until
“MONO” disappears.
Changing the display item
Each time you press
(DSPL)
, the item changes
as follows:
Frequency
y
Clock
Other Functions
Adjusting the sound
characteristics
You can adjust the bass, treble, balance, and
fader. You can store the bass and treble levels.
Each source can store the bass and treble levels
independently.
1
Select the item you want to adjust by
pressing
(SOUND)
repeatedly.
BAS (bass)
t
TRE (treble)
t
BALANCE (left-right)
t
FADER (front-rear)
t
VOL (volume)
2
Adjust the selected item by pressing
(+)
or
(-)
.
Adjust within three seconds after selecting
the item. (After three seconds, the buttons
function reverts to volume control.)
Cancel the beep sound
Press
(6)
while pressing
(SOUND)
.
To obtain the beep sound again, press these
buttons again.
Note
If you connect an optional power amplifier and do
not use the built-in amplifier, the beep sound will
be deactivated.
