15
15
CDP-C5CS
CDP-C5CS
SECTION 6
DIAGRAMS
For Schematic Diagrams.
Note:
• All capacitors are in
µ
F unless otherwise noted. (p: pF)
50 WV or less are not indicated except for electrolytics and
tantalums.
• All resistors are in
Ω
and
1
/
4
W or less unless otherwise
specified.
•
f
: internal component.
•
C
: panel designation.
•
A
: B+ Line.
•
B
: B– Line.
• Voltages and waveforms are dc with respect to ground un-
der no-signal (detuned) conditions.
no mark : CD PLAY
• Voltages are taken with a VOM (Input impedance 10 M
Ω
).
Voltage variations may be noted due to normal production
tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal production
tolerances.
• Circled numbers refer to waveforms.
• Signal path.
J
: CD PLAY
c
: DIGITAL OUT
For Printed Wiring Boards.
Note:
•
X
: parts extracted from the component side.
•
a
: Through hole.
•
: Pattern from the side which enables seeing.
(The other layers' patterns are not indicated.)
• Indication of transistor
THIS NOTE IS COMMON FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is printed in each block.)
Note:
The components identi-
fied by mark
0
or dot-
ted line with mark
0
are
critical for safety.
Replace only with part
number specified.
Note:
Les composants identifiés
par une marque
0
sont cri-
tiques pour la sécurité.
Ne les remplacer que par une
piéce por tant le numéro
spécifié.
Caution:
Pattern face side:
Parts on the pattern face side seen from
(Conductor Side)
the pattern face are indicated.
Parts face side:
Parts on the parts face side seen from
(Component Side) the parts face are indicated.
B
These are omitted.
C
E
Q
B
These are omitted.
C
E
Q
• Circuit Boards Location
BD board
JUNCTION board
IR-IN board
DISPLAY board
MAIN board
KEY board
POWER SW board
LOADING MOTOR board
HP board
SENSOR board
