Sony CD Walkman D-EJ855, Руководство по обслуживанию

Страница: 2 / 44

2
D-EJ855
Notes on chip component replacement
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be dam-
aged by heat.
Flexible Circuit Board Repairing
• Keep the temperature of the soldering iron around 270 ˚C dur-
ing repairing.
• Do not touch the soldering iron on the same conductor of the
circuit board (within 3 times).
• Be careful not to apply force on the conductor when soldering
or unsoldering.
TABLE OF CONTENTS
1. SERVICING NOTES
............................................... 3
2. GENERAL
................................................................... 6
3. DISASSEMBLY
3-1. Disassembly Flow ........................................................... 7
3-2. Upper Lid (M) Sub Assy ................................................. 7
3-3. Cabinret (Upper) Sub Assy ............................................. 8
3-4. MAIN Board, Optical Pick-up Section
(CDM-3325ES) ............................................................... 8
4. ELECTRICAL CHECK
.......................................... 9
5. DIAGRAMS
5-1. Block Diagram – MAIN Section (1/2) – ....................... 10
5-2. Block Diagram – MAIN Section (2/2) – ....................... 11
5-3. Block Diagram – POWER SUPPLY Section – ............. 12
5-4. Note for Printed Wiring Boards and
Schematic Diagrams ....................................................... 13
5-5. Printed Wiring Board ...................................................... 14
5-6. Schematic Diagram – MAIN Board (1/3) – .................. 15
5-7. Schematic Diagram – MAIN Board (2/3) – .................. 16
5-8. Schematic Diagram – MAIN Board (3/3) – .................. 17
5-9. IC Pin Function Description ........................................... 18
6. EXPLODED VIEWS
6-1. Upper Lid, Cabinet (Upper) Section .............................. 25
6-2. Cabinet (Lower) Section ................................................. 26
3-4. Optical Pick-up Section (CDM-3325ES) ....................... 27
7. ELECTRICAL PARTS LIST
............................... 28
This appliance is classified as a CLASS 1 LASER product.
The CLASS 1 LASER PRODUCT MARKING is located on
the rear exterior.
CAUTION
Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous ra-
diation exposure.
On AC power adaptor
• Use only the AC power adaptor supplied or
recommended in “Accessories (supplied/
optional).” Do not use any other AC power
adaptor. It may cause a malfunction.
Polarity of the plug
SAFETY-RELATED COMPONENT WARNING!!
COMPONENTS IDENTIFIED BY MARK
0
OR DOTTED
LINE WITH MARK
0
ON THE SCHEMATIC DIAGRAMS
AND IN THE PARTS LIST ARE CRITICAL TO SAFE
OPERATION. REPLACE THESE COMPONENTS WITH
SONY PARTS WHOSE PART NUMBERS APPEAR AS
SHOWN IN THIS MANUAL OR IN SUPPLEMENTS PUB-
LISHED BY SONY.
ATTENTION AU COMPOSANT AYANT RAPPORT
À LA SÉCURITÉ!
LES COMPOSANTS IDENTIFIÉS PAR UNE MARQUE 0
SUR LES DIAGRAMMES SCHÉMATIQUES ET LA LISTE
DES PIÈCES SONT CRITIQUES POUR LA SÉCURITÉ
DE FONCTIONNEMENT. NE REMPLACER CES COM-
POSANTS QUE PAR DES PIÈCES SONY DONT LES
NUMÉROS SONT DONNÉS DANS CE MANUEL OU
DANS LES SUPPLÉMENTS PUBLIÉS PAR SONY.