32
Troubleshooting / Specifications
Troubleshooting
This section may help you isolate the cause of a problem
and as a result, eliminate the need to contact technical
support.
The unit cannot be operated
The key protection
function is on. Press and hold the KEY INHIBIT
button for more than two seconds to set the protection
of the setting value to off.
Or, a function that does not work is assigned to a
function button. When the menu is not displayed,
press the menu selection control to confirm the
functions assigned to function buttons.
The black bars appear at the left and right positions
of the display
When the signal aspect ratio is
different from that of the panel, the black bars appear.
This is not a failure of the unit.
Adjustments and settings cannot be made
Adjustments and settings may not be possible
depending on the input signals and the status of the
unit. See “Input Signals and Adjustable/Setting Items”
(page 14).
The screen becomes dark and the unit turns off
If the internal temperature of the unit increases,
the screen may become dark and the unit may turn off.
Check if the ventilation slots or vents are blocked with
something such as dust.
In this case, refer to Sony qualified service personnel.
Color is not displayed correctly
Check the
[Interface Format] display or the [Signal Format],
[Color Temp.], or [Color Space] setting.
Specifications
Picture performance
Panel
OLED panel
Picture size (diagonal)
750.2 mm (29
1
/
2
inches)
Effective picture size (H × V)
663.6 × 349.9 mm
(26
1
/
4
× 13
7
/
8
inches)
Resolution (H × V)
4096 × 2160 pixels
Aspect
17:9
Pixel efficiency 99.99%
Panel drive
RGB 10-bit
Viewing angle (Panel specification)
89°/89°/89°/89° (typical)
(up/down/left/right, contrast > 10:1)
Scan
0% scan (fixed)
Color temperature
D65, D93, D61, D55, DCI
Warm-up time Approx. 30 minutes
To provide stable picture quality, turn
on the power of the monitor and
leave it in this state for more than 30
minutes.
Input
SDI (3G/HD) input
BNC type (4)
Input impedance: 75 Ω unbalanced
Serial remote (LAN)
RJ-45 modular connector (1)
Ethernet (10BASE-T/100BASE-TX)
Output
SDI (3G/HD) output
BNC type (4)
Output impedance: 75 Ω unbalanced
Audio monitor output connector
Stereo mini jack (1)
Headphones output connector
Stereo mini jack (1)
General
Power
AC 100 V to 240 V, 2.8 A to 1.2 A, 50/
60 Hz
Power consumption
Approx. 280 W (max.)
Approx. 150 W (average power
consumption in the default status)
Inrush current (1) Maximum possible inrush current
at initial switch-on (Voltage changes
caused by manual switching):
72 A peak, 7 A r.m.s. (240V AC)
Содержание BVM-X300
Страница 42: ...Sony Corporation ...