Sony BRC-X400, Руководство по эксплуатации, Страница: 80 / 104

80
Tracking data output tab (BRC-
X400/X401)
The unit can output tracking data compliant with
the free-d protocol from the LAN connector to
work with various systems, such as virtual studio
systems.
The tracking data is output using UDP packets in
sync with the external sync signal.
Enable
Insert a check mark to enable the output of
tracking data.
Destination IP address
When [Transfer mode] is set to [Always], specify
the IP address of the client which will receive the
tracking data from the camera.
UDP port number
When [Transfer mode] is set to [Always], specify
the UDP port of the client which will receive the
tracking data from the camera.
When [Transfer mode] is set to [On demand],
specify the UDP port number on which the
camera will listen for messages from the client.
Transfer mode
Set the output control method for the tracking
data.
[Always]: Always output tracking data.
[On demand]: Start/stop output of tracking data in
accordance with a “Type D0 (poll/command)”
message from the client.
Camera ID
Set the ID for identifying the camera.
When [Transfer mode] is set to [On demand], the
unit controls the output of tracking data using
messages specified by Type D0 commands of
the free-d protocol.
The unit supports the following commands.
00 (Stop stream mode): Stop output.
01 (Start stream mode): Start output.
In addition, the tracking data output from the
unit is stored and output as shown below
according to the format specified by the Type D1
command of the free-d protocol.
Camera ID: Stores the configured camera ID.
Camera Pan Angle: Stores the pan angle of the unit
in a format specified by the free-d protocol.
Camera Tilt Angle: Stores the tilt angle of the unit in
a format specified by the free-d protocol.
Camera Roll Angle: Not supported (always 0)
Camera X-Position: Not supported (always 0)
Camera Y-Position: Not supported (always 0)
Camera Height (Z-Position): Not supported (always
0)
Camera Zoom: Store the zoom position of the unit
in the same format as VISCA commands.
Camera Focus: Store the focus position in the same
format as VISCA commands.
Spare/Undefined Data: Stores the frame count
from the upper 4 bits (0h to Fh) and the iris
value (F value) of the unit from the lower 12
bits multiplied by 100.
Notes
• When mounted on a ceiling, set [IMG FLIP] in
the SYSTEM menu to [ON] so that the Camera
Pan Angle and Camera Tilt Angle data is in the
correct orientation.
• The [TELE CONVERT MODE] magnification
setting has no effect on the Camera Zoom
value.
• If the tracking data is delayed or the value
update falls behind, change to the following
settings.
Do not use the streaming function.
Set a minimum value for [Frame rate 1] of
[Image 1] in the Video codec tab.
Select [Off] for [Image 2]/[Image 3] Codec.
Clear the checkbox of [Image] in the
Superimpose tab.
Clear the checkbox of [Enable] in the Audio tab.