3
US
US
FCC Related Information
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
Safety and Regulatory
This device complies with Industry Canada licence-exempt
RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including
interference that may cause undesired operation of the
device.
To prevent radio interference to the licensed service, this
device is intended to be operated indoors and away from
windows to provide maximum shielding. Equipment (or its
transmit antenna) that is installed outdoors is subject to
licensing.
Only use Wireless LAN indoors when using it with IEEE
802.11a (5 GHz).
This equipment complies with FCC/IC radiation exposure
limits set forth for uncontrolled equipment and meets the
FCC radio frequency (RF) Exposure Guidelines in
Supplement C to OET65 and RSS-102 of the IC radio
frequency (RF) Exposure rules. This equipment has very low
levels of RF energy that it deemed to comply without
maximum permissive exposure evaluation (MPE). But it is
desirable that it should be installed and operated with at
least 20 cm and more between the radiator and person’s
body (excluding extremities: hands, wrists, feet and
ankles).
This device and its antenna(s) must not be co-located or
operating with any other antenna or transmitter except
Grant condition.
Note
This television includes a QAM demodulator which should
allow you to receive unscrambled digital cable television
programming via subscription service to a cable service
provider. Availability of digital cable television
programming in your area depends on the type of
programming and signal provided by your cable service
provider.
WALL-MOUNT BRACKET
Below information shows the correct handling of the Wall-
Mount Bracket. Be sure to read this information thoroughly
and use the Wall-Mount Bracket correctly.
To Customers:
Be sure to observe the following precautions for safety to
prevent a serious injury through fire, electric shock, the
product toppling over, or the product dropping.
• Be sure to subcontract the installation to licensed
contractors and keep small children away during
installation.
• Be sure to subcontract moving or dismounting of the TV
to licensed contractors.
• Do not remove screws, etc., after mounting the TV.
• Do not make alterations to the parts of the Wall-Mount
Bracket.
• Do not mount any equipment other than the specified
product.
• Do not apply any load other than the TV on the Wall-
Mount Bracket.
• Do not lean on or hang from the TV.
• Do not handle the TV with excessive force during cleaning
or maintenance.
To Sony Dealers and Contractors:
The following instructions are for Sony dealers and
contractors only. Be sure to read safety precautions
described below and pay special attention to safety during
the installation, maintenance and checking of this product.
• When handling or mounting the TV set, hold it on the
sides. Do not lift the TV by the U-shaped Bar.
• Do not install the Wall-Mount Bracket on wall surfaces
where the corners or the sides of the TV are protruding
away from the wall surface.
• Do not install the TV over or under an air-conditioner.
Safety information
Declaration of Conformity
Trade Name: SONY
Model: XBR-75X910C/XBR-65X900C/XBR-55X900C
Responsible Party: Sony Electronics Inc.
Address: 16530 Via Esprillo,
San Diego, CA 92127 U.S.A.
Telephone Number: 858-942-2230
This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
Pursuant to FCC regulations, you are cautioned that any
changes or modifications not expressly approved in this
manual could void your authority to operate this
equipment.
U-shaped Bar
U-shaped Bar
Содержание Bravia XBR-75X910C
