Sony BRAVIA VPL-VW90ES, Руководство по эксплуатации

Страница: 71 / 100

71
Oth
e
rs
On-screen display
Remote control
The picture is too dark.
c
Adjust “Contrast” or “Brightness” on the Picture menu
properly (
1
pages 52, 53).
The picture is not clear.
c
Adjust the focus (
1
page 20).
c
Condensation has accumulated on the lens. Leave the projector
for about 2 hours with the power on.
The picture flickers.
c
For pictures from a computer, activate “APA” and adjust the
current input signal.
c Adjust “Phase” for “Adjust Signal” on the Screen menu
properly (
1
page 58).
The color of characters or
the picture is not
appropriate. c Select the desired color registration in “Panel Alignment” of
Installation
menu (
1
page 66).
Image is left on the screen.
(image retention)
c
When high contrast non-moving images are displayed for a long
period of time, there may be some image retention on the
screen. This is only a temporary condition. Turning off the
power for a while will eliminate the retained image.
Symptom Cause and Remedy
Symptom Cause and Remedy
On-screen display does not
appear. c Set “Status” on the Setup menu to “On” ( 1 page 59).
c
Check if the ON/STANDBY indicator should light in green.
The model name does not
disappear from the screen.
Or else, the demo mode is
displayed continuously.
c
The display mode of the projector may be set at the time of
purchase. Consult with your local dealer or qualified Sony
personnel.
Input terminals do not
appear. c Set “Auto Input Search” on the Function menu to “Off” ( 1
page 63).
Symptom Cause and Remedy
The remote control does
not work. c Batteries could be weak. Replace them with new batteries
(
1
page 12).
c Insert the batteries with the correct polarities ( 1 page 12).
c If there is a fluorescent lamp near the remote control detector, the
projector may work improperly or inadvertently.
c
Confirm the position of the remote control detector on the
projector (
1 page 8).
c Set “IR Receiver” to “Front & Rear” on the Installation menu
(
1
page 65).